spi: sprd: adi: Remove redundant address bits setting
[linux/fpc-iii.git] / drivers / hwspinlock / omap_hwspinlock.c
blob14e1a532ebb56e9805fcf035b3d960e9b5398a8c
1 // SPDX-License-Identifier: GPL-2.0
2 /*
3 * OMAP hardware spinlock driver
5 * Copyright (C) 2010-2015 Texas Instruments Incorporated - http://www.ti.com
7 * Contact: Simon Que <sque@ti.com>
8 * Hari Kanigeri <h-kanigeri2@ti.com>
9 * Ohad Ben-Cohen <ohad@wizery.com>
12 #include <linux/kernel.h>
13 #include <linux/module.h>
14 #include <linux/device.h>
15 #include <linux/delay.h>
16 #include <linux/io.h>
17 #include <linux/bitops.h>
18 #include <linux/pm_runtime.h>
19 #include <linux/slab.h>
20 #include <linux/spinlock.h>
21 #include <linux/hwspinlock.h>
22 #include <linux/of.h>
23 #include <linux/platform_device.h>
25 #include "hwspinlock_internal.h"
27 /* Spinlock register offsets */
28 #define SYSSTATUS_OFFSET 0x0014
29 #define LOCK_BASE_OFFSET 0x0800
31 #define SPINLOCK_NUMLOCKS_BIT_OFFSET (24)
33 /* Possible values of SPINLOCK_LOCK_REG */
34 #define SPINLOCK_NOTTAKEN (0) /* free */
35 #define SPINLOCK_TAKEN (1) /* locked */
37 static int omap_hwspinlock_trylock(struct hwspinlock *lock)
39 void __iomem *lock_addr = lock->priv;
41 /* attempt to acquire the lock by reading its value */
42 return (SPINLOCK_NOTTAKEN == readl(lock_addr));
45 static void omap_hwspinlock_unlock(struct hwspinlock *lock)
47 void __iomem *lock_addr = lock->priv;
49 /* release the lock by writing 0 to it */
50 writel(SPINLOCK_NOTTAKEN, lock_addr);
54 * relax the OMAP interconnect while spinning on it.
56 * The specs recommended that the retry delay time will be
57 * just over half of the time that a requester would be
58 * expected to hold the lock.
60 * The number below is taken from an hardware specs example,
61 * obviously it is somewhat arbitrary.
63 static void omap_hwspinlock_relax(struct hwspinlock *lock)
65 ndelay(50);
68 static const struct hwspinlock_ops omap_hwspinlock_ops = {
69 .trylock = omap_hwspinlock_trylock,
70 .unlock = omap_hwspinlock_unlock,
71 .relax = omap_hwspinlock_relax,
74 static int omap_hwspinlock_probe(struct platform_device *pdev)
76 struct device_node *node = pdev->dev.of_node;
77 struct hwspinlock_device *bank;
78 struct hwspinlock *hwlock;
79 struct resource *res;
80 void __iomem *io_base;
81 int num_locks, i, ret;
82 /* Only a single hwspinlock block device is supported */
83 int base_id = 0;
85 if (!node)
86 return -ENODEV;
88 res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
89 if (!res)
90 return -ENODEV;
92 io_base = ioremap(res->start, resource_size(res));
93 if (!io_base)
94 return -ENOMEM;
97 * make sure the module is enabled and clocked before reading
98 * the module SYSSTATUS register
100 pm_runtime_enable(&pdev->dev);
101 ret = pm_runtime_get_sync(&pdev->dev);
102 if (ret < 0) {
103 pm_runtime_put_noidle(&pdev->dev);
104 goto iounmap_base;
107 /* Determine number of locks */
108 i = readl(io_base + SYSSTATUS_OFFSET);
109 i >>= SPINLOCK_NUMLOCKS_BIT_OFFSET;
112 * runtime PM will make sure the clock of this module is
113 * enabled again iff at least one lock is requested
115 ret = pm_runtime_put(&pdev->dev);
116 if (ret < 0)
117 goto iounmap_base;
119 /* one of the four lsb's must be set, and nothing else */
120 if (hweight_long(i & 0xf) != 1 || i > 8) {
121 ret = -EINVAL;
122 goto iounmap_base;
125 num_locks = i * 32; /* actual number of locks in this device */
127 bank = kzalloc(struct_size(bank, lock, num_locks), GFP_KERNEL);
128 if (!bank) {
129 ret = -ENOMEM;
130 goto iounmap_base;
133 platform_set_drvdata(pdev, bank);
135 for (i = 0, hwlock = &bank->lock[0]; i < num_locks; i++, hwlock++)
136 hwlock->priv = io_base + LOCK_BASE_OFFSET + sizeof(u32) * i;
138 ret = hwspin_lock_register(bank, &pdev->dev, &omap_hwspinlock_ops,
139 base_id, num_locks);
140 if (ret)
141 goto reg_fail;
143 dev_dbg(&pdev->dev, "Registered %d locks with HwSpinlock core\n",
144 num_locks);
146 return 0;
148 reg_fail:
149 kfree(bank);
150 iounmap_base:
151 pm_runtime_disable(&pdev->dev);
152 iounmap(io_base);
153 return ret;
156 static int omap_hwspinlock_remove(struct platform_device *pdev)
158 struct hwspinlock_device *bank = platform_get_drvdata(pdev);
159 void __iomem *io_base = bank->lock[0].priv - LOCK_BASE_OFFSET;
160 int ret;
162 ret = hwspin_lock_unregister(bank);
163 if (ret) {
164 dev_err(&pdev->dev, "%s failed: %d\n", __func__, ret);
165 return ret;
168 pm_runtime_disable(&pdev->dev);
169 iounmap(io_base);
170 kfree(bank);
172 return 0;
175 static const struct of_device_id omap_hwspinlock_of_match[] = {
176 { .compatible = "ti,omap4-hwspinlock", },
177 { .compatible = "ti,am654-hwspinlock", },
178 { /* end */ },
180 MODULE_DEVICE_TABLE(of, omap_hwspinlock_of_match);
182 static struct platform_driver omap_hwspinlock_driver = {
183 .probe = omap_hwspinlock_probe,
184 .remove = omap_hwspinlock_remove,
185 .driver = {
186 .name = "omap_hwspinlock",
187 .of_match_table = of_match_ptr(omap_hwspinlock_of_match),
191 static int __init omap_hwspinlock_init(void)
193 return platform_driver_register(&omap_hwspinlock_driver);
195 /* board init code might need to reserve hwspinlocks for predefined purposes */
196 postcore_initcall(omap_hwspinlock_init);
198 static void __exit omap_hwspinlock_exit(void)
200 platform_driver_unregister(&omap_hwspinlock_driver);
202 module_exit(omap_hwspinlock_exit);
204 MODULE_LICENSE("GPL v2");
205 MODULE_DESCRIPTION("Hardware spinlock driver for OMAP");
206 MODULE_AUTHOR("Simon Que <sque@ti.com>");
207 MODULE_AUTHOR("Hari Kanigeri <h-kanigeri2@ti.com>");
208 MODULE_AUTHOR("Ohad Ben-Cohen <ohad@wizery.com>");