arch/mips/mti-malta/malta-smtc.c

   1 /*
   2  * Malta Platform-specific hooks for SMP operation
   3  */
   4 #include <linux/irq.h>
   5 #include <linux/init.h>
   6
   7 #include <asm/mipsregs.h>
   8 #include <asm/mipsmtregs.h>
   9 #include <asm/smtc.h>
  10 #include <asm/smtc_ipi.h>
  11
  12 /* VPE/SMP Prototype implements platform interfaces directly */
  13
  14 /*
  15  * Cause the specified action to be performed on a targeted "CPU"
  16  */
  17
  18 static void msmtc_send_ipi_single(int cpu, unsigned int action)
  19 {
  20         /* "CPU" may be TC of same VPE, VPE of same CPU, or different CPU */
  21         smtc_send_ipi(cpu, LINUX_SMP_IPI, action);
  22 }
  23
  24 static void msmtc_send_ipi_mask(const struct cpumask *mask, unsigned int action)
  25 {
  26         unsigned int i;
  27
  28         for_each_cpu(i, mask)
  29                 msmtc_send_ipi_single(i, action);
  30 }
  31
  32 /*
  33  * Post-config but pre-boot cleanup entry point
  34  */
  35 static void msmtc_init_secondary(void)
  36 {
  37         int myvpe;
  38
  39         /* Don't enable Malta I/O interrupts (IP2) for secondary VPEs */
  40         myvpe = read_c0_tcbind() & TCBIND_CURVPE;
  41         if (myvpe != 0) {
  42                 /* Ideally, this should be done only once per VPE, but... */
  43                 clear_c0_status(ST0_IM);
  44                 set_c0_status((0x100 << cp0_compare_irq)
  45                                 | (0x100 << MIPS_CPU_IPI_IRQ));
  46                 if (cp0_perfcount_irq >= 0)
  47                         set_c0_status(0x100 << cp0_perfcount_irq);
  48         }
  49
  50         smtc_init_secondary();
  51 }
  52
  53 /*
  54  * Platform "CPU" startup hook
  55  */
  56 static void msmtc_boot_secondary(int cpu, struct task_struct *idle)
  57 {
  58         smtc_boot_secondary(cpu, idle);
  59 }
  60
  61 /*
  62  * SMP initialization finalization entry point
  63  */
  64 static void msmtc_smp_finish(void)
  65 {
  66         smtc_smp_finish();
  67 }
  68
  69 /*
  70  * Hook for after all CPUs are online
  71  */
  72
  73 static void msmtc_cpus_done(void)
  74 {
  75 }
  76
  77 /*
  78  * Platform SMP pre-initialization
  79  *
  80  * As noted above, we can assume a single CPU for now
  81  * but it may be multithreaded.
  82  */
  83
  84 static void __init msmtc_smp_setup(void)
  85 {
  86         /*
  87          * we won't get the definitive value until
  88          * we've run smtc_prepare_cpus later, but
  89          * we would appear to need an upper bound now.
  90          */
  91         smp_num_siblings = smtc_build_cpu_map(0);
  92 }
  93
  94 static void __init msmtc_prepare_cpus(unsigned int max_cpus)
  95 {
  96         smtc_prepare_cpus(max_cpus);
  97 }
  98
  99 struct plat_smp_ops msmtc_smp_ops = {
 100         .send_ipi_single        = msmtc_send_ipi_single,
 101         .send_ipi_mask          = msmtc_send_ipi_mask,
 102         .init_secondary         = msmtc_init_secondary,
 103         .smp_finish             = msmtc_smp_finish,
 104         .cpus_done              = msmtc_cpus_done,
 105         .boot_secondary         = msmtc_boot_secondary,
 106         .smp_setup              = msmtc_smp_setup,
 107         .prepare_cpus           = msmtc_prepare_cpus,
 108 };
 109
 110 #ifdef CONFIG_MIPS_MT_SMTC_IRQAFF
 111 /*
 112  * IRQ affinity hook
 113  */
 114
 115
 116 int plat_set_irq_affinity(struct irq_data *d, const struct cpumask *affinity,
 117                           bool force)
 118 {
 119         cpumask_t tmask;
 120         int cpu = 0;
 121         void smtc_set_irq_affinity(unsigned int irq, cpumask_t aff);
 122
 123         /*
 124          * On the legacy Malta development board, all I/O interrupts
 125          * are routed through the 8259 and combined in a single signal
 126          * to the CPU daughterboard, and on the CoreFPGA2/3 34K models,
 127          * that signal is brought to IP2 of both VPEs. To avoid racing
 128          * concurrent interrupt service events, IP2 is enabled only on
 129          * one VPE, by convention VPE0.  So long as no bits are ever
 130          * cleared in the affinity mask, there will never be any
 131          * interrupt forwarding.  But as soon as a program or operator
 132          * sets affinity for one of the related IRQs, we need to make
 133          * sure that we don't ever try to forward across the VPE boundary,
 134          * at least not until we engineer a system where the interrupt
 135          * _ack() or _end() function can somehow know that it corresponds
 136          * to an interrupt taken on another VPE, and perform the appropriate
 137          * restoration of Status.IM state using MFTR/MTTR instead of the
 138          * normal local behavior. We also ensure that no attempt will
 139          * be made to forward to an offline "CPU".
 140          */
 141
 142         cpumask_copy(&tmask, affinity);
 143         for_each_cpu(cpu, affinity) {
 144                 if ((cpu_data[cpu].vpe_id != 0) || !cpu_online(cpu))
 145                         cpu_clear(cpu, tmask);
 146         }
 147         cpumask_copy(d->affinity, &tmask);
 148
 149         if (cpus_empty(tmask))
 150                 /*
 151                  * We could restore a default mask here, but the
 152                  * runtime code can anyway deal with the null set
 153                  */
 154                 printk(KERN_WARNING
 155                        "IRQ affinity leaves no legal CPU for IRQ %d\n", d->irq);
 156
 157         /* Do any generic SMTC IRQ affinity setup */
 158         smtc_set_irq_affinity(d->irq, tmask);
 159
 160         return IRQ_SET_MASK_OK_NOCOPY;
 161 }
 162 #endif /* CONFIG_MIPS_MT_SMTC_IRQAFF */