2 Kernel NFS Server Statistics
3 ============================
5 This document describes the format and semantics of the statistics
6 which the kernel NFS server makes available to userspace. These
7 statistics are available in several text form pseudo files, each of
8 which is described separately below.
10 In most cases you don't need to know these formats, as the nfsstat(8)
11 program from the nfs-utils distribution provides a helpful command-line
12 interface for extracting and printing them.
14 All the files described here are formatted as a sequence of text lines,
15 separated by newline '\n' characters. Lines beginning with a hash
16 '#' character are comments intended for humans and should be ignored
17 by parsing routines. All other lines contain a sequence of fields
18 separated by whitespace.
20 /proc/fs/nfsd/pool_stats
21 ------------------------
23 This file is available in kernels from 2.6.30 onwards, if the
24 /proc/fs/nfsd filesystem is mounted (it almost always should be).
26 The first line is a comment which describes the fields present in
27 all the other lines. The other lines present the following data as
28 a sequence of unsigned decimal numeric fields. One line is shown
29 for each NFS thread pool.
31 All counters are 64 bits wide and wrap naturally. There is no way
32 to zero these counters, instead applications should do their own
36 The id number of the NFS thread pool to which this line applies.
37 This number does not change.
39 Thread pool ids are a contiguous set of small integers starting
40 at zero. The maximum value depends on the thread pool mode, but
41 currently cannot be larger than the number of CPUs in the system.
42 Note that in the default case there will be a single thread pool
43 which contains all the nfsd threads and all the CPUs in the system,
44 and thus this file will have a single line with a pool id of "0".
47 Counts how many NFS packets have arrived. More precisely, this
48 is the number of times that the network stack has notified the
49 sunrpc server layer that new data may be available on a transport
50 (e.g. an NFS or UDP socket or an NFS/RDMA endpoint).
52 Depending on the NFS workload patterns and various network stack
53 effects (such as Large Receive Offload) which can combine packets
54 on the wire, this may be either more or less than the number
55 of NFS calls received (which statistic is available elsewhere).
56 However this is a more accurate and less workload-dependent measure
57 of how much CPU load is being placed on the sunrpc server layer
58 due to NFS network traffic.
61 Counts how many times an NFS transport is enqueued to wait for
62 an nfsd thread to service it, i.e. no nfsd thread was considered
65 The circumstance this statistic tracks indicates that there was NFS
66 network-facing work to be done but it couldn't be done immediately,
67 thus introducing a small delay in servicing NFS calls. The ideal
68 rate of change for this counter is zero; significantly non-zero
69 values may indicate a performance limitation.
71 This can happen because there are too few nfsd threads in the thread
72 pool for the NFS workload (the workload is thread-limited), in which
73 case configuring more nfsd threads will probably improve the
74 performance of the NFS workload.
77 Counts how many times an idle nfsd thread is woken to try to
78 receive some data from an NFS transport.
80 This statistic tracks the circumstance where incoming
81 network-facing NFS work is being handled quickly, which is a good
82 thing. The ideal rate of change for this counter will be close
83 to but less than the rate of change of the packets-arrived counter.
86 Counts how many times an nfsd thread triggered an idle timeout,
87 i.e. was not woken to handle any incoming network packets for
90 This statistic counts a circumstance where there are more nfsd
91 threads configured than can be used by the NFS workload. This is
92 a clue that the number of nfsd threads can be reduced without
93 affecting performance. Unfortunately, it's only a clue and not
94 a strong indication, for a couple of reasons:
96 - Currently the rate at which the counter is incremented is quite
97 slow; the idle timeout is 60 minutes. Unless the NFS workload
98 remains constant for hours at a time, this counter is unlikely
99 to be providing information that is still useful.
101 - It is usually a wise policy to provide some slack,
102 i.e. configure a few more nfsds than are currently needed,
103 to allow for future spikes in load.
106 Note that incoming packets on NFS transports will be dealt with in
107 one of three ways. An nfsd thread can be woken (threads-woken counts
108 this case), or the transport can be enqueued for later attention
109 (sockets-enqueued counts this case), or the packet can be temporarily
110 deferred because the transport is currently being used by an nfsd
111 thread. This last case is not very interesting and is not explicitly
112 counted, but can be inferred from the other counters thus:
114 packets-deferred = packets-arrived - ( sockets-enqueued + threads-woken )
119 Descriptions of the other statistics file should go here.
122 Greg Banks <gnb@sgi.com>