2 * Copyright (C) 2000 - 2007 Jeff Dike (jdike@{addtoit,linux.intel}.com)
3 * Licensed under the GPL
7 #include <linux/sched.h>
8 #include <linux/hardirq.h>
9 #include <linux/module.h>
10 #include <linux/uaccess.h>
11 #include <asm/current.h>
12 #include <asm/pgtable.h>
13 #include <asm/tlbflush.h>
15 #include <as-layout.h>
16 #include <kern_util.h>
21 * Note this is constrained to return 0, -EFAULT, -EACCESS, -ENOMEM by
24 int handle_page_fault(unsigned long address
, unsigned long ip
,
25 int is_write
, int is_user
, int *code_out
)
27 struct mm_struct
*mm
= current
->mm
;
28 struct vm_area_struct
*vma
;
34 unsigned int flags
= FAULT_FLAG_ALLOW_RETRY
| FAULT_FLAG_KILLABLE
;
36 *code_out
= SEGV_MAPERR
;
39 * If the fault was with pagefaults disabled, don't take the fault, just
42 if (faulthandler_disabled())
46 flags
|= FAULT_FLAG_USER
;
48 down_read(&mm
->mmap_sem
);
49 vma
= find_vma(mm
, address
);
52 else if (vma
->vm_start
<= address
)
54 else if (!(vma
->vm_flags
& VM_GROWSDOWN
))
56 else if (is_user
&& !ARCH_IS_STACKGROW(address
))
58 else if (expand_stack(vma
, address
))
62 *code_out
= SEGV_ACCERR
;
64 if (!(vma
->vm_flags
& VM_WRITE
))
66 flags
|= FAULT_FLAG_WRITE
;
68 /* Don't require VM_READ|VM_EXEC for write faults! */
69 if (!(vma
->vm_flags
& (VM_READ
| VM_EXEC
)))
76 fault
= handle_mm_fault(mm
, vma
, address
, flags
);
78 if ((fault
& VM_FAULT_RETRY
) && fatal_signal_pending(current
))
81 if (unlikely(fault
& VM_FAULT_ERROR
)) {
82 if (fault
& VM_FAULT_OOM
) {
84 } else if (fault
& VM_FAULT_SIGSEGV
) {
86 } else if (fault
& VM_FAULT_SIGBUS
) {
92 if (flags
& FAULT_FLAG_ALLOW_RETRY
) {
93 if (fault
& VM_FAULT_MAJOR
)
97 if (fault
& VM_FAULT_RETRY
) {
98 flags
&= ~FAULT_FLAG_ALLOW_RETRY
;
99 flags
|= FAULT_FLAG_TRIED
;
105 pgd
= pgd_offset(mm
, address
);
106 pud
= pud_offset(pgd
, address
);
107 pmd
= pmd_offset(pud
, address
);
108 pte
= pte_offset_kernel(pmd
, address
);
109 } while (!pte_present(*pte
));
112 * The below warning was added in place of
113 * pte_mkyoung(); if (is_write) pte_mkdirty();
114 * If it's triggered, we'd see normally a hang here (a clean pte is
115 * marked read-only to emulate the dirty bit).
116 * However, the generic code can mark a PTE writable but clean on a
117 * concurrent read fault, triggering this harmlessly. So comment it out.
120 WARN_ON(!pte_young(*pte
) || (is_write
&& !pte_dirty(*pte
)));
122 flush_tlb_page(vma
, address
);
124 up_read(&mm
->mmap_sem
);
130 * We ran out of memory, call the OOM killer, and return the userspace
131 * (which will retry the fault, or kill us if we got oom-killed).
133 up_read(&mm
->mmap_sem
);
135 goto out_nosemaphore
;
136 pagefault_out_of_memory();
139 EXPORT_SYMBOL(handle_page_fault
);
141 static void show_segv_info(struct uml_pt_regs
*regs
)
143 struct task_struct
*tsk
= current
;
144 struct faultinfo
*fi
= UPT_FAULTINFO(regs
);
146 if (!unhandled_signal(tsk
, SIGSEGV
))
149 if (!printk_ratelimit())
152 printk("%s%s[%d]: segfault at %lx ip %p sp %p error %x",
153 task_pid_nr(tsk
) > 1 ? KERN_INFO
: KERN_EMERG
,
154 tsk
->comm
, task_pid_nr(tsk
), FAULT_ADDRESS(*fi
),
155 (void *)UPT_IP(regs
), (void *)UPT_SP(regs
),
158 print_vma_addr(KERN_CONT
" in ", UPT_IP(regs
));
159 printk(KERN_CONT
"\n");
162 static void bad_segv(struct faultinfo fi
, unsigned long ip
)
166 si
.si_signo
= SIGSEGV
;
167 si
.si_code
= SEGV_ACCERR
;
168 si
.si_addr
= (void __user
*) FAULT_ADDRESS(fi
);
169 current
->thread
.arch
.faultinfo
= fi
;
170 force_sig_info(SIGSEGV
, &si
, current
);
173 void fatal_sigsegv(void)
175 force_sigsegv(SIGSEGV
, current
);
178 * This is to tell gcc that we're not returning - do_signal
179 * can, in general, return, but in this case, it's not, since
180 * we just got a fatal SIGSEGV queued.
185 void segv_handler(int sig
, struct siginfo
*unused_si
, struct uml_pt_regs
*regs
)
187 struct faultinfo
* fi
= UPT_FAULTINFO(regs
);
189 if (UPT_IS_USER(regs
) && !SEGV_IS_FIXABLE(fi
)) {
190 show_segv_info(regs
);
191 bad_segv(*fi
, UPT_IP(regs
));
194 segv(*fi
, UPT_IP(regs
), UPT_IS_USER(regs
), regs
);
198 * We give a *copy* of the faultinfo in the regs to segv.
199 * This must be done, since nesting SEGVs could overwrite
200 * the info in the regs. A pointer to the info then would
203 unsigned long segv(struct faultinfo fi
, unsigned long ip
, int is_user
,
204 struct uml_pt_regs
*regs
)
209 int is_write
= FAULT_WRITE(fi
);
210 unsigned long address
= FAULT_ADDRESS(fi
);
212 if (!is_user
&& regs
)
213 current
->thread
.segv_regs
= container_of(regs
, struct pt_regs
, regs
);
215 if (!is_user
&& (address
>= start_vm
) && (address
< end_vm
)) {
216 flush_tlb_kernel_vm();
219 else if (current
->mm
== NULL
) {
220 show_regs(container_of(regs
, struct pt_regs
, regs
));
221 panic("Segfault with no mm");
223 else if (!is_user
&& address
< TASK_SIZE
) {
224 show_regs(container_of(regs
, struct pt_regs
, regs
));
225 panic("Kernel tried to access user memory at addr 0x%lx, ip 0x%lx",
229 if (SEGV_IS_FIXABLE(&fi
))
230 err
= handle_page_fault(address
, ip
, is_write
, is_user
,
235 * A thread accessed NULL, we get a fault, but CR2 is invalid.
236 * This code is used in __do_copy_from_user() of TT mode.
237 * XXX tt mode is gone, so maybe this isn't needed any more
242 catcher
= current
->thread
.fault_catcher
;
245 else if (catcher
!= NULL
) {
246 current
->thread
.fault_addr
= (void *) address
;
247 UML_LONGJMP(catcher
, 1);
249 else if (current
->thread
.fault_addr
!= NULL
)
250 panic("fault_addr set but no fault catcher");
251 else if (!is_user
&& arch_fixup(ip
, regs
))
255 show_regs(container_of(regs
, struct pt_regs
, regs
));
256 panic("Kernel mode fault at addr 0x%lx, ip 0x%lx",
260 show_segv_info(regs
);
262 if (err
== -EACCES
) {
263 si
.si_signo
= SIGBUS
;
265 si
.si_code
= BUS_ADRERR
;
266 si
.si_addr
= (void __user
*)address
;
267 current
->thread
.arch
.faultinfo
= fi
;
268 force_sig_info(SIGBUS
, &si
, current
);
270 BUG_ON(err
!= -EFAULT
);
271 si
.si_signo
= SIGSEGV
;
272 si
.si_addr
= (void __user
*) address
;
273 current
->thread
.arch
.faultinfo
= fi
;
274 force_sig_info(SIGSEGV
, &si
, current
);
279 current
->thread
.segv_regs
= NULL
;
284 void relay_signal(int sig
, struct siginfo
*si
, struct uml_pt_regs
*regs
)
286 struct faultinfo
*fi
;
287 struct siginfo clean_si
;
289 if (!UPT_IS_USER(regs
)) {
291 printk(KERN_ERR
"Bus error - the host /dev/shm or /tmp "
292 "mount likely just ran out of space\n");
293 panic("Kernel mode signal %d", sig
);
296 arch_examine_signal(sig
, regs
);
298 memset(&clean_si
, 0, sizeof(clean_si
));
299 clean_si
.si_signo
= si
->si_signo
;
300 clean_si
.si_errno
= si
->si_errno
;
301 clean_si
.si_code
= si
->si_code
;
308 fi
= UPT_FAULTINFO(regs
);
309 clean_si
.si_addr
= (void __user
*) FAULT_ADDRESS(*fi
);
310 current
->thread
.arch
.faultinfo
= *fi
;
311 #ifdef __ARCH_SI_TRAPNO
312 clean_si
.si_trapno
= si
->si_trapno
;
316 printk(KERN_ERR
"Attempted to relay unknown signal %d (si_code = %d)\n",
320 force_sig_info(sig
, &clean_si
, current
);
323 void bus_handler(int sig
, struct siginfo
*si
, struct uml_pt_regs
*regs
)
325 if (current
->thread
.fault_catcher
!= NULL
)
326 UML_LONGJMP(current
->thread
.fault_catcher
, 1);
328 relay_signal(sig
, si
, regs
);
331 void winch(int sig
, struct siginfo
*unused_si
, struct uml_pt_regs
*regs
)
333 do_IRQ(WINCH_IRQ
, regs
);