arch/arm/boot/dts/kirkwood-ns2-common.dtsi

   1 #include "kirkwood.dtsi"
   2 #include "kirkwood-6281.dtsi"
   3
   4 / {
   5         chosen {
   6                 bootargs = "console=ttyS0,115200n8";
   7                 stdout-path = &uart0;
   8         };
   9
  10         ocp@f1000000 {
  11                 pinctrl: pin-controller@10000 {
  12                         pmx_ns2_sata0: pmx-ns2-sata0 {
  13                                 marvell,pins = "mpp21";
  14                                 marvell,function = "sata0";
  15                         };
  16                         pmx_ns2_sata1: pmx-ns2-sata1 {
  17                                 marvell,pins = "mpp20";
  18                                 marvell,function = "sata1";
  19                         };
  20                 };
  21
  22                 serial@12000 {
  23                         status = "okay";
  24                 };
  25
  26                 spi@10600 {
  27                         status = "okay";
  28
  29                         flash@0 {
  30                                 #address-cells = <1>;
  31                                 #size-cells = <1>;
  32                                 compatible = "mxicy,mx25l4005a", "jedec,spi-nor";
  33                                 reg = <0>;
  34                                 spi-max-frequency = <20000000>;
  35                                 mode = <0>;
  36
  37                                 partition@0 {
  38                                         reg = <0x0 0x80000>;
  39                                         label = "u-boot";
  40                                 };
  41                         };
  42                 };
  43
  44                 i2c@11000 {
  45                         status = "okay";
  46
  47                         eeprom@50 {
  48                                 compatible = "atmel,24c04";
  49                                 pagesize = <16>;
  50                                 reg = <0x50>;
  51                         };
  52                 };
  53         };
  54
  55         gpio_keys {
  56                 compatible = "gpio-keys";
  57                 #address-cells = <1>;
  58                 #size-cells = <0>;
  59
  60                 power {
  61                         label = "Power push button";
  62                         linux,code = <KEY_POWER>;
  63                         gpios = <&gpio1 0 GPIO_ACTIVE_HIGH>;
  64                 };
  65         };
  66
  67         gpio-leds {
  68                 compatible = "gpio-leds";
  69
  70                 red-fail {
  71                         label = "ns2:red:fail";
  72                         gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>;
  73                 };
  74         };
  75
  76         gpio_poweroff {
  77                 compatible = "gpio-poweroff";
  78                 gpios = <&gpio0 31 GPIO_ACTIVE_HIGH>;
  79         };
  80
  81 };
  82
  83 &mdio {
  84         status = "okay";
  85
  86         ethphy0: ethernet-phy@X {
  87                 /* overwrite reg property in board file */
  88         };
  89 };
  90
  91 &eth0 {
  92         status = "okay";
  93         ethernet0-port@0 {
  94                 phy-handle = <&ethphy0>;
  95         };
  96 };