2 * Linux ARCnet driver - "raw mode" packet encapsulation (no soft headers)
4 * Written 1994-1999 by Avery Pennarun.
5 * Derived from skeleton.c by Donald Becker.
7 * Special thanks to Contemporary Controls, Inc. (www.ccontrols.com)
8 * for sponsoring the further development of this driver.
10 * **********************
12 * The original copyright of skeleton.c was as follows:
14 * skeleton.c Written 1993 by Donald Becker.
15 * Copyright 1993 United States Government as represented by the
16 * Director, National Security Agency. This software may only be used
17 * and distributed according to the terms of the GNU General Public License as
18 * modified by SRC, incorporated herein by reference.
20 * **********************
22 * For more details, see drivers/net/arcnet.c
24 * **********************
27 #define pr_fmt(fmt) "arcnet:" KBUILD_MODNAME ": " fmt
29 #include <linux/module.h>
30 #include <linux/gfp.h>
31 #include <linux/init.h>
32 #include <linux/if_arp.h>
34 #include <linux/netdevice.h>
35 #include <linux/skbuff.h>
36 #include "arcdevice.h"
39 static void rx(struct net_device
*dev
, int bufnum
,
40 struct archdr
*pkthdr
, int length
)
42 struct arcnet_local
*lp
= netdev_priv(dev
);
44 struct archdr
*pkt
= pkthdr
;
47 arc_printk(D_DURING
, dev
, "it's a raw packet (length=%d)\n", length
);
54 skb
= alloc_skb(length
+ ARC_HDR_SIZE
, GFP_ATOMIC
);
56 dev
->stats
.rx_dropped
++;
59 skb_put(skb
, length
+ ARC_HDR_SIZE
);
62 pkt
= (struct archdr
*)skb
->data
;
64 skb_reset_mac_header(skb
);
65 skb_pull(skb
, ARC_HDR_SIZE
);
67 /* up to sizeof(pkt->soft) has already been copied from the card */
68 memcpy(pkt
, pkthdr
, sizeof(struct archdr
));
69 if (length
> sizeof(pkt
->soft
))
70 lp
->hw
.copy_from_card(dev
, bufnum
, ofs
+ sizeof(pkt
->soft
),
71 pkt
->soft
.raw
+ sizeof(pkt
->soft
),
72 length
- sizeof(pkt
->soft
));
75 arcnet_dump_skb(dev
, skb
, "rx");
77 skb
->protocol
= cpu_to_be16(ETH_P_ARCNET
);
81 /* Create the ARCnet hard/soft headers for raw mode.
82 * There aren't any soft headers in raw mode - not even the protocol id.
84 static int build_header(struct sk_buff
*skb
, struct net_device
*dev
,
85 unsigned short type
, uint8_t daddr
)
87 int hdr_size
= ARC_HDR_SIZE
;
88 struct archdr
*pkt
= skb_push(skb
, hdr_size
);
90 /* Set the source hardware address.
92 * This is pretty pointless for most purposes, but it can help in
93 * debugging. ARCnet does not allow us to change the source address
94 * in the actual packet sent.
96 pkt
->hard
.source
= *dev
->dev_addr
;
98 /* see linux/net/ethernet/eth.c to see where I got the following */
100 if (dev
->flags
& (IFF_LOOPBACK
| IFF_NOARP
)) {
101 /* FIXME: fill in the last byte of the dest ipaddr here
102 * to better comply with RFC1051 in "noarp" mode.
107 /* otherwise, just fill it in and go! */
108 pkt
->hard
.dest
= daddr
;
110 return hdr_size
; /* success */
113 static int prepare_tx(struct net_device
*dev
, struct archdr
*pkt
, int length
,
116 struct arcnet_local
*lp
= netdev_priv(dev
);
117 struct arc_hardware
*hard
= &pkt
->hard
;
120 arc_printk(D_DURING
, dev
, "prepare_tx: txbufs=%d/%d/%d\n",
121 lp
->next_tx
, lp
->cur_tx
, bufnum
);
123 /* hard header is not included in packet length */
124 length
-= ARC_HDR_SIZE
;
127 /* should never happen! other people already check for this. */
128 arc_printk(D_NORMAL
, dev
, "Bug! prepare_tx with size %d (> %d)\n",
132 if (length
>= MinTU
) {
134 hard
->offset
[1] = ofs
= 512 - length
;
135 } else if (length
> MTU
) {
137 hard
->offset
[1] = ofs
= 512 - length
- 3;
139 hard
->offset
[0] = ofs
= 256 - length
;
142 arc_printk(D_DURING
, dev
, "prepare_tx: length=%d ofs=%d\n",
145 lp
->hw
.copy_to_card(dev
, bufnum
, 0, hard
, ARC_HDR_SIZE
);
146 lp
->hw
.copy_to_card(dev
, bufnum
, ofs
, &pkt
->soft
, length
);
148 lp
->lastload_dest
= hard
->dest
;
153 static struct ArcProto rawmode_proto
= {
157 .build_header
= build_header
,
158 .prepare_tx
= prepare_tx
,
163 static int __init
arcnet_raw_init(void)
167 pr_info("raw mode (`r') encapsulation support loaded\n");
169 for (count
= 0; count
< 256; count
++)
170 if (arc_proto_map
[count
] == arc_proto_default
)
171 arc_proto_map
[count
] = &rawmode_proto
;
173 /* for raw mode, we only set the bcast proto if there's no better one */
174 if (arc_bcast_proto
== arc_proto_default
)
175 arc_bcast_proto
= &rawmode_proto
;
177 arc_proto_default
= &rawmode_proto
;
181 static void __exit
arcnet_raw_exit(void)
183 arcnet_unregister_proto(&rawmode_proto
);
186 module_init(arcnet_raw_init
);
187 module_exit(arcnet_raw_exit
);
189 MODULE_LICENSE("GPL");