arch/arm/boot/dts/kirkwood-98dx4122.dtsi

   1 / {
   2         mbus@f1000000 {
   3                 pciec: pcie-controller@82000000 {
   4                         compatible = "marvell,kirkwood-pcie";
   5                         status = "disabled";
   6                         device_type = "pci";
   7
   8                         #address-cells = <3>;
   9                         #size-cells = <2>;
  10
  11                         bus-range = <0x00 0xff>;
  12
  13                         ranges =
  14                                <0x82000000 0 0x40000 MBUS_ID(0xf0, 0x01) 0x40000 0 0x00002000
  15                                 0x82000000 0x1 0     MBUS_ID(0x04, 0xe8) 0       1 0 /* Port 0.0 MEM */
  16                                 0x81000000 0x1 0     MBUS_ID(0x04, 0xe0) 0       1 0 /* Port 0.0 IO  */>;
  17
  18                         pcie0: pcie@1,0 {
  19                                 device_type = "pci";
  20                                 assigned-addresses = <0x82000800 0 0x00040000 0 0x2000>;
  21                                 reg = <0x0800 0 0 0 0>;
  22                                 #address-cells = <3>;
  23                                 #size-cells = <2>;
  24                                 #interrupt-cells = <1>;
  25                                 ranges = <0x82000000 0 0 0x82000000 0x1 0 1 0
  26                                           0x81000000 0 0 0x81000000 0x1 0 1 0>;
  27                                 interrupt-map-mask = <0 0 0 0>;
  28                                 interrupt-map = <0 0 0 0 &intc 9>;
  29                                 marvell,pcie-port = <0>;
  30                                 marvell,pcie-lane = <0>;
  31                                 clocks = <&gate_clk 2>;
  32                                 status = "disabled";
  33                         };
  34                 };
  35         };
  36
  37         ocp@f1000000 {
  38                 pinctrl: pin-controller@10000 {
  39                         compatible = "marvell,98dx4122-pinctrl";
  40
  41                 };
  42         };
  43 };
  44
  45 &sata_phy0 {
  46         status = "disabled";
  47 };
  48
  49 &sata_phy1 {
  50         status = "disabled";
  51 };