2 * OMAP hardware spinlock driver
4 * Copyright (C) 2010-2015 Texas Instruments Incorporated - http://www.ti.com
6 * Contact: Simon Que <sque@ti.com>
7 * Hari Kanigeri <h-kanigeri2@ti.com>
8 * Ohad Ben-Cohen <ohad@wizery.com>
10 * This program is free software; you can redistribute it and/or
11 * modify it under the terms of the GNU General Public License
12 * version 2 as published by the Free Software Foundation.
14 * This program is distributed in the hope that it will be useful, but
15 * WITHOUT ANY WARRANTY; without even the implied warranty of
16 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
17 * General Public License for more details.
20 #include <linux/kernel.h>
21 #include <linux/module.h>
22 #include <linux/device.h>
23 #include <linux/delay.h>
25 #include <linux/bitops.h>
26 #include <linux/pm_runtime.h>
27 #include <linux/slab.h>
28 #include <linux/spinlock.h>
29 #include <linux/hwspinlock.h>
31 #include <linux/platform_device.h>
33 #include "hwspinlock_internal.h"
35 /* Spinlock register offsets */
36 #define SYSSTATUS_OFFSET 0x0014
37 #define LOCK_BASE_OFFSET 0x0800
39 #define SPINLOCK_NUMLOCKS_BIT_OFFSET (24)
41 /* Possible values of SPINLOCK_LOCK_REG */
42 #define SPINLOCK_NOTTAKEN (0) /* free */
43 #define SPINLOCK_TAKEN (1) /* locked */
45 static int omap_hwspinlock_trylock(struct hwspinlock
*lock
)
47 void __iomem
*lock_addr
= lock
->priv
;
49 /* attempt to acquire the lock by reading its value */
50 return (SPINLOCK_NOTTAKEN
== readl(lock_addr
));
53 static void omap_hwspinlock_unlock(struct hwspinlock
*lock
)
55 void __iomem
*lock_addr
= lock
->priv
;
57 /* release the lock by writing 0 to it */
58 writel(SPINLOCK_NOTTAKEN
, lock_addr
);
62 * relax the OMAP interconnect while spinning on it.
64 * The specs recommended that the retry delay time will be
65 * just over half of the time that a requester would be
66 * expected to hold the lock.
68 * The number below is taken from an hardware specs example,
69 * obviously it is somewhat arbitrary.
71 static void omap_hwspinlock_relax(struct hwspinlock
*lock
)
76 static const struct hwspinlock_ops omap_hwspinlock_ops
= {
77 .trylock
= omap_hwspinlock_trylock
,
78 .unlock
= omap_hwspinlock_unlock
,
79 .relax
= omap_hwspinlock_relax
,
82 static int omap_hwspinlock_probe(struct platform_device
*pdev
)
84 struct device_node
*node
= pdev
->dev
.of_node
;
85 struct hwspinlock_device
*bank
;
86 struct hwspinlock
*hwlock
;
88 void __iomem
*io_base
;
89 int num_locks
, i
, ret
;
90 /* Only a single hwspinlock block device is supported */
96 res
= platform_get_resource(pdev
, IORESOURCE_MEM
, 0);
100 io_base
= ioremap(res
->start
, resource_size(res
));
105 * make sure the module is enabled and clocked before reading
106 * the module SYSSTATUS register
108 pm_runtime_enable(&pdev
->dev
);
109 ret
= pm_runtime_get_sync(&pdev
->dev
);
111 pm_runtime_put_noidle(&pdev
->dev
);
115 /* Determine number of locks */
116 i
= readl(io_base
+ SYSSTATUS_OFFSET
);
117 i
>>= SPINLOCK_NUMLOCKS_BIT_OFFSET
;
120 * runtime PM will make sure the clock of this module is
121 * enabled again iff at least one lock is requested
123 ret
= pm_runtime_put(&pdev
->dev
);
127 /* one of the four lsb's must be set, and nothing else */
128 if (hweight_long(i
& 0xf) != 1 || i
> 8) {
133 num_locks
= i
* 32; /* actual number of locks in this device */
135 bank
= kzalloc(sizeof(*bank
) + num_locks
* sizeof(*hwlock
), GFP_KERNEL
);
141 platform_set_drvdata(pdev
, bank
);
143 for (i
= 0, hwlock
= &bank
->lock
[0]; i
< num_locks
; i
++, hwlock
++)
144 hwlock
->priv
= io_base
+ LOCK_BASE_OFFSET
+ sizeof(u32
) * i
;
146 ret
= hwspin_lock_register(bank
, &pdev
->dev
, &omap_hwspinlock_ops
,
156 pm_runtime_disable(&pdev
->dev
);
161 static int omap_hwspinlock_remove(struct platform_device
*pdev
)
163 struct hwspinlock_device
*bank
= platform_get_drvdata(pdev
);
164 void __iomem
*io_base
= bank
->lock
[0].priv
- LOCK_BASE_OFFSET
;
167 ret
= hwspin_lock_unregister(bank
);
169 dev_err(&pdev
->dev
, "%s failed: %d\n", __func__
, ret
);
173 pm_runtime_disable(&pdev
->dev
);
180 static const struct of_device_id omap_hwspinlock_of_match
[] = {
181 { .compatible
= "ti,omap4-hwspinlock", },
184 MODULE_DEVICE_TABLE(of
, omap_hwspinlock_of_match
);
186 static struct platform_driver omap_hwspinlock_driver
= {
187 .probe
= omap_hwspinlock_probe
,
188 .remove
= omap_hwspinlock_remove
,
190 .name
= "omap_hwspinlock",
191 .of_match_table
= of_match_ptr(omap_hwspinlock_of_match
),
195 static int __init
omap_hwspinlock_init(void)
197 return platform_driver_register(&omap_hwspinlock_driver
);
199 /* board init code might need to reserve hwspinlocks for predefined purposes */
200 postcore_initcall(omap_hwspinlock_init
);
202 static void __exit
omap_hwspinlock_exit(void)
204 platform_driver_unregister(&omap_hwspinlock_driver
);
206 module_exit(omap_hwspinlock_exit
);
208 MODULE_LICENSE("GPL v2");
209 MODULE_DESCRIPTION("Hardware spinlock driver for OMAP");
210 MODULE_AUTHOR("Simon Que <sque@ti.com>");
211 MODULE_AUTHOR("Hari Kanigeri <h-kanigeri2@ti.com>");
212 MODULE_AUTHOR("Ohad Ben-Cohen <ohad@wizery.com>");