1 .\" $NetBSD: hardware,v 1.10 2008/09/06 22:19:03 tsutsui Exp $
15 Single Board Computers.
17 The minimal configuration requires 8 MB of RAM and ~200 MB of disk space.
18 To install the entire system requires much more disk space.
19 To run X (clients only) or compile the system, more RAM is recommended.
20 Good performance requires 16 MB of RAM, or 32 MB
21 when running the X Window System.
23 Note that you can install
26 on a system with only 4 MB of onboard RAM, but you will need to use a
27 VMEbus RAM card with at least another 4 MB to augment the onboard
28 memory in order to actually install the system.
30 A swap partition of 2-3*RAM is recommended.
34 installation procedure uses a
36 image which is placed into the swap area of the disk.
37 The swap partition must be large enough to hold this miniroot image
40 .Ss2 Supported VME147 hardware
41 .(bullet -offset indent
55 On-board centronics style printer port
60 On-board Lance Ethernet (le)
65 Most SCSI disks, tapes, CD-ROMs, etc
67 On-board wd33c93 SCSI bus interface chip (async only)
72 Battery-backed real-time clock
76 Any VMEbus interface cards with Machine Independent drivers
80 .Ss2 Supported VME162/VME172 hardware
81 .(bullet -offset indent
95 On-board Intel Ethernet (ie)
100 Most SCSI disks, tapes, CD-ROMs, etc
102 On-board ncr53c710 SCSI I/O processor chip
107 Battery-backed real-time clock
111 Any VMEbus interface cards with Machine Independent drivers
115 .Ss2 Supported VME167/VME177 hardware
116 .(bullet -offset indent
130 On-board centronics style printer port
135 On-board Intel Ethernet (ie)
140 Most SCSI disks, tapes, CD-ROMs, etc
142 On-board ncr53c710 SCSI I/O Processor chip
147 Battery-backed real-time clock
151 Any VMEbus interface cards with Machine Independent drivers
156 If it's not on the above lists, there is no support for it in this release.