drivers/parport/parport_amiga.c

   1 /* Low-level parallel port routines for the Amiga built-in port
   2  *
   3  * Author: Joerg Dorchain <joerg@dorchain.net>
   4  *
   5  * This is a complete rewrite of the code, but based heaviy upon the old
   6  * lp_intern. code.
   7  *
   8  * The built-in Amiga parallel port provides one port at a fixed address
   9  * with 8 bidirectional data lines (D0 - D7) and 3 bidirectional status
  10  * lines (BUSY, POUT, SEL), 1 output control line /STROBE (raised automatically
  11  * in hardware when the data register is accessed), and 1 input control line
  12  * /ACK, able to cause an interrupt, but both not directly settable by
  13  * software.
  14  */
  15
  16 #include <linux/module.h>
  17 #include <linux/init.h>
  18 #include <linux/parport.h>
  19 #include <linux/ioport.h>
  20 #include <linux/interrupt.h>
  21 #include <asm/setup.h>
  22 #include <asm/amigahw.h>
  23 #include <asm/irq.h>
  24 #include <asm/io.h>
  25 #include <asm/amigaints.h>
  26
  27 #undef DEBUG
  28 #ifdef DEBUG
  29 #define DPRINTK printk
  30 #else
  31 #define DPRINTK(x...)   do { } while (0)
  32 #endif
  33
  34 static struct parport *this_port = NULL;
  35
  36 static void amiga_write_data(struct parport *p, unsigned char data)
  37 {
  38         DPRINTK(KERN_DEBUG "write_data %c\n",data);
  39         /* Triggers also /STROBE. This behavior cannot be changed */
  40         ciaa.prb = data;
  41         mb();
  42 }
  43
  44 static unsigned char amiga_read_data(struct parport *p)
  45 {
  46         /* Triggers also /STROBE. This behavior cannot be changed */
  47         return ciaa.prb;
  48 }
  49
  50 #if 0
  51 static unsigned char control_pc_to_amiga(unsigned char control)
  52 {
  53         unsigned char ret = 0;
  54
  55         if (control & PARPORT_CONTROL_SELECT) /* XXX: What is SELECP? */
  56                 ;
  57         if (control & PARPORT_CONTROL_INIT) /* INITP */
  58                 /* reset connected to cpu reset pin */;
  59         if (control & PARPORT_CONTROL_AUTOFD) /* AUTOLF */
  60                 /* Not connected */;
  61         if (control & PARPORT_CONTROL_STROBE) /* Strobe */
  62                 /* Handled only directly by hardware */;
  63         return ret;
  64 }
  65 #endif
  66
  67 static unsigned char control_amiga_to_pc(unsigned char control)
  68 {
  69         return PARPORT_CONTROL_SELECT |
  70               PARPORT_CONTROL_AUTOFD | PARPORT_CONTROL_STROBE;
  71         /* fake value: interrupt enable, select in, no reset,
  72         no autolf, no strobe - seems to be closest the wiring diagram */
  73 }
  74
  75 static void amiga_write_control(struct parport *p, unsigned char control)
  76 {
  77         DPRINTK(KERN_DEBUG "write_control %02x\n",control);
  78         /* No implementation possible */
  79 }
  80
  81 static unsigned char amiga_read_control( struct parport *p)
  82 {
  83         DPRINTK(KERN_DEBUG "read_control \n");
  84         return control_amiga_to_pc(0);
  85 }
  86
  87 static unsigned char amiga_frob_control( struct parport *p, unsigned char mask, unsigned char val)
  88 {
  89         unsigned char old;
  90
  91         DPRINTK(KERN_DEBUG "frob_control mask %02x, value %02x\n",mask,val);
  92         old = amiga_read_control(p);
  93         amiga_write_control(p, (old & ~mask) ^ val);
  94         return old;
  95 }
  96
  97 #if 0 /* currently unused */
  98 static unsigned char status_pc_to_amiga(unsigned char status)
  99 {
 100         unsigned char ret = 1;
 101
 102         if (status & PARPORT_STATUS_BUSY) /* Busy */
 103                 ret &= ~1;
 104         if (status & PARPORT_STATUS_ACK) /* Ack */
 105                 /* handled in hardware */;
 106         if (status & PARPORT_STATUS_PAPEROUT) /* PaperOut */
 107                 ret |= 2;
 108         if (status & PARPORT_STATUS_SELECT) /* select */
 109                 ret |= 4;
 110         if (status & PARPORT_STATUS_ERROR) /* error */
 111                 /* not connected */;
 112         return ret;
 113 }
 114 #endif
 115
 116 static unsigned char status_amiga_to_pc(unsigned char status)
 117 {
 118         unsigned char ret = PARPORT_STATUS_BUSY | PARPORT_STATUS_ACK | PARPORT_STATUS_ERROR;
 119
 120         if (status & 1) /* Busy */
 121                 ret &= ~PARPORT_STATUS_BUSY;
 122         if (status & 2) /* PaperOut */
 123                 ret |= PARPORT_STATUS_PAPEROUT;
 124         if (status & 4) /* Selected */
 125                 ret |= PARPORT_STATUS_SELECT;
 126         /* the rest is not connected or handled autonomously in hardware */
 127
 128         return ret;
 129 }
 130
 131 static unsigned char amiga_read_status(struct parport *p)
 132 {
 133         unsigned char status;
 134
 135         status = status_amiga_to_pc(ciab.pra & 7);
 136         DPRINTK(KERN_DEBUG "read_status %02x\n", status);
 137         return status;
 138 }
 139
 140 /* as this ports irq handling is already done, we use a generic funktion */
 141 static irqreturn_t amiga_interrupt(int irq, void *dev_id)
 142 {
 143         parport_generic_irq(irq, (struct parport *) dev_id);
 144         return IRQ_HANDLED;
 145 }
 146
 147 static void amiga_enable_irq(struct parport *p)
 148 {
 149         enable_irq(IRQ_AMIGA_CIAA_FLG);
 150 }
 151
 152 static void amiga_disable_irq(struct parport *p)
 153 {
 154         disable_irq(IRQ_AMIGA_CIAA_FLG);
 155 }
 156
 157 static void amiga_data_forward(struct parport *p)
 158 {
 159         DPRINTK(KERN_DEBUG "forward\n");
 160         ciaa.ddrb = 0xff; /* all pins output */
 161         mb();
 162 }
 163
 164 static void amiga_data_reverse(struct parport *p)
 165 {
 166         DPRINTK(KERN_DEBUG "reverse\n");
 167         ciaa.ddrb = 0; /* all pins input */
 168         mb();
 169 }
 170
 171 static void amiga_init_state(struct pardevice *dev, struct parport_state *s)
 172 {
 173         s->u.amiga.data = 0;
 174         s->u.amiga.datadir = 255;
 175         s->u.amiga.status = 0;
 176         s->u.amiga.statusdir = 0;
 177 }
 178
 179 static void amiga_save_state(struct parport *p, struct parport_state *s)
 180 {
 181         mb();
 182         s->u.amiga.data = ciaa.prb;
 183         s->u.amiga.datadir = ciaa.ddrb;
 184         s->u.amiga.status = ciab.pra & 7;
 185         s->u.amiga.statusdir = ciab.ddra & 7;
 186         mb();
 187 }
 188
 189 static void amiga_restore_state(struct parport *p, struct parport_state *s)
 190 {
 191         mb();
 192         ciaa.prb = s->u.amiga.data;
 193         ciaa.ddrb = s->u.amiga.datadir;
 194         ciab.pra |= (ciab.pra & 0xf8) | s->u.amiga.status;
 195         ciab.ddra |= (ciab.ddra & 0xf8) | s->u.amiga.statusdir;
 196         mb();
 197 }
 198
 199 static struct parport_operations pp_amiga_ops = {
 200         .write_data     = amiga_write_data,
 201         .read_data      = amiga_read_data,
 202
 203         .write_control  = amiga_write_control,
 204         .read_control   = amiga_read_control,
 205         .frob_control   = amiga_frob_control,
 206
 207         .read_status    = amiga_read_status,
 208
 209         .enable_irq     = amiga_enable_irq,
 210         .disable_irq    = amiga_disable_irq,
 211
 212         .data_forward   = amiga_data_forward,
 213         .data_reverse   = amiga_data_reverse,
 214
 215         .init_state     = amiga_init_state,
 216         .save_state     = amiga_save_state,
 217         .restore_state  = amiga_restore_state,
 218
 219         .epp_write_data = parport_ieee1284_epp_write_data,
 220         .epp_read_data  = parport_ieee1284_epp_read_data,
 221         .epp_write_addr = parport_ieee1284_epp_write_addr,
 222         .epp_read_addr  = parport_ieee1284_epp_read_addr,
 223
 224         .ecp_write_data = parport_ieee1284_ecp_write_data,
 225         .ecp_read_data  = parport_ieee1284_ecp_read_data,
 226         .ecp_write_addr = parport_ieee1284_ecp_write_addr,
 227
 228         .compat_write_data      = parport_ieee1284_write_compat,
 229         .nibble_read_data       = parport_ieee1284_read_nibble,
 230         .byte_read_data         = parport_ieee1284_read_byte,
 231
 232         .owner          = THIS_MODULE,
 233 };
 234
 235 /* ----------- Initialisation code --------------------------------- */
 236
 237 static int __init parport_amiga_init(void)
 238 {
 239         struct parport *p;
 240         int err;
 241
 242         if (!MACH_IS_AMIGA || !AMIGAHW_PRESENT(AMI_PARALLEL))
 243                 return -ENODEV;
 244
 245         err = -EBUSY;
 246         if (!request_mem_region(CIAA_PHYSADDR-1+0x100, 0x100, "parallel"))
 247                 goto out_mem;
 248
 249         ciaa.ddrb = 0xff;
 250         ciab.ddra &= 0xf8;
 251         mb();
 252
 253         p = parport_register_port((unsigned long)&ciaa.prb, IRQ_AMIGA_CIAA_FLG,
 254                                    PARPORT_DMA_NONE, &pp_amiga_ops);
 255         if (!p)
 256                 goto out_port;
 257
 258         err = request_irq(IRQ_AMIGA_CIAA_FLG, amiga_interrupt, 0, p->name, p);
 259         if (err)
 260                 goto out_irq;
 261
 262         this_port = p;
 263         printk(KERN_INFO "%s: Amiga built-in port using irq\n", p->name);
 264         /* XXX: set operating mode */
 265         parport_announce_port(p);
 266
 267         return 0;
 268
 269 out_irq:
 270         parport_put_port(p);
 271 out_port:
 272         release_mem_region(CIAA_PHYSADDR-1+0x100, 0x100);
 273 out_mem:
 274         return err;
 275 }
 276
 277 static void __exit parport_amiga_exit(void)
 278 {
 279         parport_remove_port(this_port);
 280         if (this_port->irq != PARPORT_IRQ_NONE)
 281                 free_irq(IRQ_AMIGA_CIAA_FLG, this_port);
 282         parport_put_port(this_port);
 283         release_mem_region(CIAA_PHYSADDR-1+0x100, 0x100);
 284 }
 285
 286
 287 MODULE_AUTHOR("Joerg Dorchain <joerg@dorchain.net>");
 288 MODULE_DESCRIPTION("Parport Driver for Amiga builtin Port");
 289 MODULE_SUPPORTED_DEVICE("Amiga builtin Parallel Port");
 290 MODULE_LICENSE("GPL");
 291
 292 module_init(parport_amiga_init)
 293 module_exit(parport_amiga_exit)