1 # ***** BEGIN LICENSE BLOCK *****
2 # Version: MPL 1.1/GPL 2.0/LGPL 2.1
4 # The contents of this file are subject to the Mozilla Public License Version
5 # 1.1 (the "License"); you may not use this file except in compliance with
6 # the License. You may obtain a copy of the License at
7 # http://www.mozilla.org/MPL/
9 # Software distributed under the License is distributed on an "AS IS" basis,
10 # WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
11 # for the specific language governing rights and limitations under the
14 # The Original Code is Mozilla Progress Dialog.
16 # The Initial Developer of the Original Code is
17 # Netscape Communications Corp.
18 # Portions created by the Initial Developer are Copyright (C) 2002
19 # the Initial Developer. All Rights Reserved.
22 # Bill Law <law@netscape.com>
24 # Alternatively, the contents of this file may be used under the terms of
25 # either the GNU General Public License Version 2 or later (the "GPL"), or
26 # the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
27 # in which case the provisions of the GPL or the LGPL are applicable instead
28 # of those above. If you wish to allow use of your version of this file only
29 # under the terms of either the GPL or the LGPL, and not to allow others to
30 # use your version of this file under the terms of the MPL, indicate your
31 # decision by deleting the provisions above and replace them with the notice
32 # and other provisions required by the GPL or the LGPL. If you do not delete
33 # the provisions above, a recipient may use your version of this file under
34 # the terms of any one of the MPL, the GPL or the LGPL.
36 # ***** END LICENSE BLOCK *****
38 readError=%S could not be saved, because the source file could not be read.\n\nTry again later, or contact the server administrator.
39 writeError=%S could not be saved, because an unknown error occurred.\n\nTry saving to a different location.
40 launchError=%S could not be opened, because an unknown error occurred.\n\nTry saving to disk first and then opening the file.
41 diskFull=There is not enough room on the disk to save %S.\n\nRemove unnecessary files from the disk and try again, or try saving in a different location.
42 readOnly=%S could not be saved, because the disk, folder, or file is write-protected.\n\nWrite-enable the disk and try again, or try saving in a different location.
43 accessError=%S could not be saved, because you cannot change the contents of that folder.\n\nChange the folder properties and try again, or try saving in a different location.
44 helperAppNotFound=%S could not be opened, because the associated helper application does not exist. Change the association in your preferences.
45 noMemory=There is not sufficient memory to complete the action you requested.\n\nQuit some applications and try again.
47 fileAlreadyExistsError=%S could not be saved, because a file already exists with the same name as the '_files' directory.\n\nTry saving to a different location.
48 fileNameTooLongError=%S could not be saved, because the file name was too long.\n\nTry saving with a shorter file name.