[PATCH] ocfs2: zero_user_page conversion
[wrt350n-kernel.git] / arch / mips / sgi-ip22 / ip22-nvram.c
blobe19d60d5fcc1b9dbdcef9267d98d21b0818f0f92
1 /*
2 * ip22-nvram.c: NVRAM and serial EEPROM handling.
4 * Copyright (C) 2003 Ladislav Michl (ladis@linux-mips.org)
5 */
6 #include <linux/module.h>
8 #include <asm/sgi/hpc3.h>
9 #include <asm/sgi/ip22.h>
11 /* Control opcode for serial eeprom */
12 #define EEPROM_READ 0xc000 /* serial memory read */
13 #define EEPROM_WEN 0x9800 /* write enable before prog modes */
14 #define EEPROM_WRITE 0xa000 /* serial memory write */
15 #define EEPROM_WRALL 0x8800 /* write all registers */
16 #define EEPROM_WDS 0x8000 /* disable all programming */
17 #define EEPROM_PRREAD 0xc000 /* read protect register */
18 #define EEPROM_PREN 0x9800 /* enable protect register mode */
19 #define EEPROM_PRCLEAR 0xffff /* clear protect register */
20 #define EEPROM_PRWRITE 0xa000 /* write protect register */
21 #define EEPROM_PRDS 0x8000 /* disable protect register, forever */
23 #define EEPROM_EPROT 0x01 /* Protect register enable */
24 #define EEPROM_CSEL 0x02 /* Chip select */
25 #define EEPROM_ECLK 0x04 /* EEPROM clock */
26 #define EEPROM_DATO 0x08 /* Data out */
27 #define EEPROM_DATI 0x10 /* Data in */
29 /* We need to use these functions early... */
30 #define delay() ({ \
31 int x; \
32 for (x=0; x<100000; x++) __asm__ __volatile__(""); })
34 #define eeprom_cs_on(ptr) ({ \
35 *ptr &= ~EEPROM_DATO; \
36 *ptr &= ~EEPROM_ECLK; \
37 *ptr &= ~EEPROM_EPROT; \
38 delay(); \
39 *ptr |= EEPROM_CSEL; \
40 *ptr |= EEPROM_ECLK; })
43 #define eeprom_cs_off(ptr) ({ \
44 *ptr &= ~EEPROM_ECLK; \
45 *ptr &= ~EEPROM_CSEL; \
46 *ptr |= EEPROM_EPROT; \
47 *ptr |= EEPROM_ECLK; })
49 #define BITS_IN_COMMAND 11
51 * clock in the nvram command and the register number. For the
52 * national semiconductor nv ram chip the op code is 3 bits and
53 * the address is 6/8 bits.
55 static inline void eeprom_cmd(unsigned int *ctrl, unsigned cmd, unsigned reg)
57 unsigned short ser_cmd;
58 int i;
60 ser_cmd = cmd | (reg << (16 - BITS_IN_COMMAND));
61 for (i = 0; i < BITS_IN_COMMAND; i++) {
62 if (ser_cmd & (1<<15)) /* if high order bit set */
63 writel(readl(ctrl) | EEPROM_DATO, ctrl);
64 else
65 writel(readl(ctrl) & ~EEPROM_DATO, ctrl);
66 writel(readl(ctrl) & ~EEPROM_ECLK, ctrl);
67 writel(readl(ctrl) | EEPROM_ECLK, ctrl);
68 ser_cmd <<= 1;
70 /* see data sheet timing diagram */
71 writel(readl(ctrl) & ~EEPROM_DATO, ctrl);
74 unsigned short ip22_eeprom_read(unsigned int *ctrl, int reg)
76 unsigned short res = 0;
77 int i;
79 writel(readl(ctrl) & ~EEPROM_EPROT, ctrl);
80 eeprom_cs_on(ctrl);
81 eeprom_cmd(ctrl, EEPROM_READ, reg);
83 /* clock the data ouf of serial mem */
84 for (i = 0; i < 16; i++) {
85 writel(readl(ctrl) & ~EEPROM_ECLK, ctrl);
86 delay();
87 writel(readl(ctrl) | EEPROM_ECLK, ctrl);
88 delay();
89 res <<= 1;
90 if (readl(ctrl) & EEPROM_DATI)
91 res |= 1;
94 eeprom_cs_off(ctrl);
96 return res;
99 EXPORT_SYMBOL(ip22_eeprom_read);
102 * Read specified register from main NVRAM
104 unsigned short ip22_nvram_read(int reg)
106 if (ip22_is_fullhouse())
107 /* IP22 (Indigo2 aka FullHouse) stores env variables into
108 * 93CS56 Microwire Bus EEPROM 2048 Bit (128x16) */
109 return ip22_eeprom_read(&hpc3c0->eeprom, reg);
110 else {
111 unsigned short tmp;
112 /* IP24 (Indy aka Guiness) uses DS1386 8K version */
113 reg <<= 1;
114 tmp = hpc3c0->bbram[reg++] & 0xff;
115 return (tmp << 8) | (hpc3c0->bbram[reg] & 0xff);
119 EXPORT_SYMBOL(ip22_nvram_read);