spi-topcliff-pch: supports a spi mode setup and bit order setup by IO control
[zen-stable.git] / arch / arm / mach-at91 / include / mach / at91sam9_sdramc.h
blob100f5a592926356db536780996a7796ff6856e91
1 /*
2 * arch/arm/mach-at91/include/mach/at91sam9_sdramc.h
4 * Copyright (C) 2007 Andrew Victor
5 * Copyright (C) 2007 Atmel Corporation.
7 * SDRAM Controllers (SDRAMC) - System peripherals registers.
8 * Based on AT91SAM9261 datasheet revision D.
10 * This program is free software; you can redistribute it and/or modify
11 * it under the terms of the GNU General Public License as published by
12 * the Free Software Foundation; either version 2 of the License, or
13 * (at your option) any later version.
16 #ifndef AT91SAM9_SDRAMC_H
17 #define AT91SAM9_SDRAMC_H
19 /* SDRAM Controller (SDRAMC) registers */
20 #define AT91_SDRAMC_MR 0x00 /* SDRAM Controller Mode Register */
21 #define AT91_SDRAMC_MODE (0xf << 0) /* Command Mode */
22 #define AT91_SDRAMC_MODE_NORMAL 0
23 #define AT91_SDRAMC_MODE_NOP 1
24 #define AT91_SDRAMC_MODE_PRECHARGE 2
25 #define AT91_SDRAMC_MODE_LMR 3
26 #define AT91_SDRAMC_MODE_REFRESH 4
27 #define AT91_SDRAMC_MODE_EXT_LMR 5
28 #define AT91_SDRAMC_MODE_DEEP 6
30 #define AT91_SDRAMC_TR 0x04 /* SDRAM Controller Refresh Timer Register */
31 #define AT91_SDRAMC_COUNT (0xfff << 0) /* Refresh Timer Counter */
33 #define AT91_SDRAMC_CR 0x08 /* SDRAM Controller Configuration Register */
34 #define AT91_SDRAMC_NC (3 << 0) /* Number of Column Bits */
35 #define AT91_SDRAMC_NC_8 (0 << 0)
36 #define AT91_SDRAMC_NC_9 (1 << 0)
37 #define AT91_SDRAMC_NC_10 (2 << 0)
38 #define AT91_SDRAMC_NC_11 (3 << 0)
39 #define AT91_SDRAMC_NR (3 << 2) /* Number of Row Bits */
40 #define AT91_SDRAMC_NR_11 (0 << 2)
41 #define AT91_SDRAMC_NR_12 (1 << 2)
42 #define AT91_SDRAMC_NR_13 (2 << 2)
43 #define AT91_SDRAMC_NB (1 << 4) /* Number of Banks */
44 #define AT91_SDRAMC_NB_2 (0 << 4)
45 #define AT91_SDRAMC_NB_4 (1 << 4)
46 #define AT91_SDRAMC_CAS (3 << 5) /* CAS Latency */
47 #define AT91_SDRAMC_CAS_1 (1 << 5)
48 #define AT91_SDRAMC_CAS_2 (2 << 5)
49 #define AT91_SDRAMC_CAS_3 (3 << 5)
50 #define AT91_SDRAMC_DBW (1 << 7) /* Data Bus Width */
51 #define AT91_SDRAMC_DBW_32 (0 << 7)
52 #define AT91_SDRAMC_DBW_16 (1 << 7)
53 #define AT91_SDRAMC_TWR (0xf << 8) /* Write Recovery Delay */
54 #define AT91_SDRAMC_TRC (0xf << 12) /* Row Cycle Delay */
55 #define AT91_SDRAMC_TRP (0xf << 16) /* Row Precharge Delay */
56 #define AT91_SDRAMC_TRCD (0xf << 20) /* Row to Column Delay */
57 #define AT91_SDRAMC_TRAS (0xf << 24) /* Active to Precharge Delay */
58 #define AT91_SDRAMC_TXSR (0xf << 28) /* Exit Self Refresh to Active Delay */
60 #define AT91_SDRAMC_LPR 0x10 /* SDRAM Controller Low Power Register */
61 #define AT91_SDRAMC_LPCB (3 << 0) /* Low-power Configurations */
62 #define AT91_SDRAMC_LPCB_DISABLE 0
63 #define AT91_SDRAMC_LPCB_SELF_REFRESH 1
64 #define AT91_SDRAMC_LPCB_POWER_DOWN 2
65 #define AT91_SDRAMC_LPCB_DEEP_POWER_DOWN 3
66 #define AT91_SDRAMC_PASR (7 << 4) /* Partial Array Self Refresh */
67 #define AT91_SDRAMC_TCSR (3 << 8) /* Temperature Compensated Self Refresh */
68 #define AT91_SDRAMC_DS (3 << 10) /* Drive Strength */
69 #define AT91_SDRAMC_TIMEOUT (3 << 12) /* Time to define when Low Power Mode is enabled */
70 #define AT91_SDRAMC_TIMEOUT_0_CLK_CYCLES (0 << 12)
71 #define AT91_SDRAMC_TIMEOUT_64_CLK_CYCLES (1 << 12)
72 #define AT91_SDRAMC_TIMEOUT_128_CLK_CYCLES (2 << 12)
74 #define AT91_SDRAMC_IER 0x14 /* SDRAM Controller Interrupt Enable Register */
75 #define AT91_SDRAMC_IDR 0x18 /* SDRAM Controller Interrupt Disable Register */
76 #define AT91_SDRAMC_IMR 0x1C /* SDRAM Controller Interrupt Mask Register */
77 #define AT91_SDRAMC_ISR 0x20 /* SDRAM Controller Interrupt Status Register */
78 #define AT91_SDRAMC_RES (1 << 0) /* Refresh Error Status */
80 #define AT91_SDRAMC_MDR 0x24 /* SDRAM Memory Device Register */
81 #define AT91_SDRAMC_MD (3 << 0) /* Memory Device Type */
82 #define AT91_SDRAMC_MD_SDRAM 0
83 #define AT91_SDRAMC_MD_LOW_POWER_SDRAM 1
85 /* Register access macros */
86 #define at91_ramc_read(num, reg) \
87 at91_sys_read(AT91_SDRAMC##num + reg)
88 #define at91_ramc_write(num, reg, value) \
89 at91_sys_write(AT91_SDRAMC##num + reg, value)
91 #endif