i2c-eg20t: change timeout value 50msec to 1000msec
[zen-stable.git] / drivers / usb / serial / ti_usb_3410_5052.h
blobf140f1b9d5c078283a18816d9afd718ca68c5be1
1 /* vi: ts=8 sw=8
3 * TI 3410/5052 USB Serial Driver Header
5 * Copyright (C) 2004 Texas Instruments
7 * This driver is based on the Linux io_ti driver, which is
8 * Copyright (C) 2000-2002 Inside Out Networks
9 * Copyright (C) 2001-2002 Greg Kroah-Hartman
11 * This program is free software; you can redistribute it and/or modify
12 * it under the terms of the GNU General Public License as published by
13 * the Free Software Foundation; either version 2 of the License, or
14 * (at your option) any later version.
16 * For questions or problems with this driver, contact Texas Instruments
17 * technical support, or Al Borchers <alborchers@steinerpoint.com>, or
18 * Peter Berger <pberger@brimson.com>.
21 #ifndef _TI_3410_5052_H_
22 #define _TI_3410_5052_H_
24 /* Configuration ids */
25 #define TI_BOOT_CONFIG 1
26 #define TI_ACTIVE_CONFIG 2
28 /* Vendor and product ids */
29 #define TI_VENDOR_ID 0x0451
30 #define IBM_VENDOR_ID 0x04b3
31 #define TI_3410_PRODUCT_ID 0x3410
32 #define IBM_4543_PRODUCT_ID 0x4543
33 #define IBM_454B_PRODUCT_ID 0x454b
34 #define IBM_454C_PRODUCT_ID 0x454c
35 #define TI_3410_EZ430_ID 0xF430 /* TI ez430 development tool */
36 #define TI_5052_BOOT_PRODUCT_ID 0x5052 /* no EEPROM, no firmware */
37 #define TI_5152_BOOT_PRODUCT_ID 0x5152 /* no EEPROM, no firmware */
38 #define TI_5052_EEPROM_PRODUCT_ID 0x505A /* EEPROM, no firmware */
39 #define TI_5052_FIRMWARE_PRODUCT_ID 0x505F /* firmware is running */
41 /* Multi-Tech vendor and product ids */
42 #define MTS_VENDOR_ID 0x06E0
43 #define MTS_GSM_NO_FW_PRODUCT_ID 0xF108
44 #define MTS_CDMA_NO_FW_PRODUCT_ID 0xF109
45 #define MTS_CDMA_PRODUCT_ID 0xF110
46 #define MTS_GSM_PRODUCT_ID 0xF111
47 #define MTS_EDGE_PRODUCT_ID 0xF112
48 #define MTS_MT9234MU_PRODUCT_ID 0xF114
49 #define MTS_MT9234ZBA_PRODUCT_ID 0xF115
50 #define MTS_MT9234ZBAOLD_PRODUCT_ID 0x0319
52 /* Abbott Diabetics vendor and product ids */
53 #define ABBOTT_VENDOR_ID 0x1a61
54 #define ABBOTT_PRODUCT_ID 0x3410
56 /* Commands */
57 #define TI_GET_VERSION 0x01
58 #define TI_GET_PORT_STATUS 0x02
59 #define TI_GET_PORT_DEV_INFO 0x03
60 #define TI_GET_CONFIG 0x04
61 #define TI_SET_CONFIG 0x05
62 #define TI_OPEN_PORT 0x06
63 #define TI_CLOSE_PORT 0x07
64 #define TI_START_PORT 0x08
65 #define TI_STOP_PORT 0x09
66 #define TI_TEST_PORT 0x0A
67 #define TI_PURGE_PORT 0x0B
68 #define TI_RESET_EXT_DEVICE 0x0C
69 #define TI_WRITE_DATA 0x80
70 #define TI_READ_DATA 0x81
71 #define TI_REQ_TYPE_CLASS 0x82
73 /* Module identifiers */
74 #define TI_I2C_PORT 0x01
75 #define TI_IEEE1284_PORT 0x02
76 #define TI_UART1_PORT 0x03
77 #define TI_UART2_PORT 0x04
78 #define TI_RAM_PORT 0x05
80 /* Modem status */
81 #define TI_MSR_DELTA_CTS 0x01
82 #define TI_MSR_DELTA_DSR 0x02
83 #define TI_MSR_DELTA_RI 0x04
84 #define TI_MSR_DELTA_CD 0x08
85 #define TI_MSR_CTS 0x10
86 #define TI_MSR_DSR 0x20
87 #define TI_MSR_RI 0x40
88 #define TI_MSR_CD 0x80
89 #define TI_MSR_DELTA_MASK 0x0F
90 #define TI_MSR_MASK 0xF0
92 /* Line status */
93 #define TI_LSR_OVERRUN_ERROR 0x01
94 #define TI_LSR_PARITY_ERROR 0x02
95 #define TI_LSR_FRAMING_ERROR 0x04
96 #define TI_LSR_BREAK 0x08
97 #define TI_LSR_ERROR 0x0F
98 #define TI_LSR_RX_FULL 0x10
99 #define TI_LSR_TX_EMPTY 0x20
101 /* Line control */
102 #define TI_LCR_BREAK 0x40
104 /* Modem control */
105 #define TI_MCR_LOOP 0x04
106 #define TI_MCR_DTR 0x10
107 #define TI_MCR_RTS 0x20
109 /* Mask settings */
110 #define TI_UART_ENABLE_RTS_IN 0x0001
111 #define TI_UART_DISABLE_RTS 0x0002
112 #define TI_UART_ENABLE_PARITY_CHECKING 0x0008
113 #define TI_UART_ENABLE_DSR_OUT 0x0010
114 #define TI_UART_ENABLE_CTS_OUT 0x0020
115 #define TI_UART_ENABLE_X_OUT 0x0040
116 #define TI_UART_ENABLE_XA_OUT 0x0080
117 #define TI_UART_ENABLE_X_IN 0x0100
118 #define TI_UART_ENABLE_DTR_IN 0x0800
119 #define TI_UART_DISABLE_DTR 0x1000
120 #define TI_UART_ENABLE_MS_INTS 0x2000
121 #define TI_UART_ENABLE_AUTO_START_DMA 0x4000
123 /* Parity */
124 #define TI_UART_NO_PARITY 0x00
125 #define TI_UART_ODD_PARITY 0x01
126 #define TI_UART_EVEN_PARITY 0x02
127 #define TI_UART_MARK_PARITY 0x03
128 #define TI_UART_SPACE_PARITY 0x04
130 /* Stop bits */
131 #define TI_UART_1_STOP_BITS 0x00
132 #define TI_UART_1_5_STOP_BITS 0x01
133 #define TI_UART_2_STOP_BITS 0x02
135 /* Bits per character */
136 #define TI_UART_5_DATA_BITS 0x00
137 #define TI_UART_6_DATA_BITS 0x01
138 #define TI_UART_7_DATA_BITS 0x02
139 #define TI_UART_8_DATA_BITS 0x03
141 /* 232/485 modes */
142 #define TI_UART_232 0x00
143 #define TI_UART_485_RECEIVER_DISABLED 0x01
144 #define TI_UART_485_RECEIVER_ENABLED 0x02
146 /* Pipe transfer mode and timeout */
147 #define TI_PIPE_MODE_CONTINOUS 0x01
148 #define TI_PIPE_MODE_MASK 0x03
149 #define TI_PIPE_TIMEOUT_MASK 0x7C
150 #define TI_PIPE_TIMEOUT_ENABLE 0x80
152 /* Config struct */
153 struct ti_uart_config {
154 __u16 wBaudRate;
155 __u16 wFlags;
156 __u8 bDataBits;
157 __u8 bParity;
158 __u8 bStopBits;
159 char cXon;
160 char cXoff;
161 __u8 bUartMode;
162 } __attribute__((packed));
164 /* Get port status */
165 struct ti_port_status {
166 __u8 bCmdCode;
167 __u8 bModuleId;
168 __u8 bErrorCode;
169 __u8 bMSR;
170 __u8 bLSR;
171 } __attribute__((packed));
173 /* Purge modes */
174 #define TI_PURGE_OUTPUT 0x00
175 #define TI_PURGE_INPUT 0x80
177 /* Read/Write data */
178 #define TI_RW_DATA_ADDR_SFR 0x10
179 #define TI_RW_DATA_ADDR_IDATA 0x20
180 #define TI_RW_DATA_ADDR_XDATA 0x30
181 #define TI_RW_DATA_ADDR_CODE 0x40
182 #define TI_RW_DATA_ADDR_GPIO 0x50
183 #define TI_RW_DATA_ADDR_I2C 0x60
184 #define TI_RW_DATA_ADDR_FLASH 0x70
185 #define TI_RW_DATA_ADDR_DSP 0x80
187 #define TI_RW_DATA_UNSPECIFIED 0x00
188 #define TI_RW_DATA_BYTE 0x01
189 #define TI_RW_DATA_WORD 0x02
190 #define TI_RW_DATA_DOUBLE_WORD 0x04
192 struct ti_write_data_bytes {
193 __u8 bAddrType;
194 __u8 bDataType;
195 __u8 bDataCounter;
196 __be16 wBaseAddrHi;
197 __be16 wBaseAddrLo;
198 __u8 bData[0];
199 } __attribute__((packed));
201 struct ti_read_data_request {
202 __u8 bAddrType;
203 __u8 bDataType;
204 __u8 bDataCounter;
205 __be16 wBaseAddrHi;
206 __be16 wBaseAddrLo;
207 } __attribute__((packed));
209 struct ti_read_data_bytes {
210 __u8 bCmdCode;
211 __u8 bModuleId;
212 __u8 bErrorCode;
213 __u8 bData[0];
214 } __attribute__((packed));
216 /* Interrupt struct */
217 struct ti_interrupt {
218 __u8 bICode;
219 __u8 bIInfo;
220 } __attribute__((packed));
222 /* Interrupt codes */
223 #define TI_GET_PORT_FROM_CODE(c) (((c) >> 4) - 3)
224 #define TI_GET_FUNC_FROM_CODE(c) ((c) & 0x0f)
225 #define TI_CODE_HARDWARE_ERROR 0xFF
226 #define TI_CODE_DATA_ERROR 0x03
227 #define TI_CODE_MODEM_STATUS 0x04
229 /* Download firmware max packet size */
230 #define TI_DOWNLOAD_MAX_PACKET_SIZE 64
232 /* Firmware image header */
233 struct ti_firmware_header {
234 __le16 wLength;
235 __u8 bCheckSum;
236 } __attribute__((packed));
238 /* UART addresses */
239 #define TI_UART1_BASE_ADDR 0xFFA0 /* UART 1 base address */
240 #define TI_UART2_BASE_ADDR 0xFFB0 /* UART 2 base address */
241 #define TI_UART_OFFSET_LCR 0x0002 /* UART MCR register offset */
242 #define TI_UART_OFFSET_MCR 0x0004 /* UART MCR register offset */
244 #endif /* _TI_3410_5052_H_ */