spi-topcliff-pch: add recovery processing in case wait-event timeout
[zen-stable.git] / include / linux / can / netlink.h
blob14966ddb7df1c5b056578ff622c77cd6400e8094
1 /*
2 * linux/can/netlink.h
4 * Definitions for the CAN netlink interface
6 * Copyright (c) 2009 Wolfgang Grandegger <wg@grandegger.com>
8 */
10 #ifndef CAN_NETLINK_H
11 #define CAN_NETLINK_H
13 #include <linux/types.h>
16 * CAN bit-timing parameters
18 * For further information, please read chapter "8 BIT TIMING
19 * REQUIREMENTS" of the "Bosch CAN Specification version 2.0"
20 * at http://www.semiconductors.bosch.de/pdf/can2spec.pdf.
22 struct can_bittiming {
23 __u32 bitrate; /* Bit-rate in bits/second */
24 __u32 sample_point; /* Sample point in one-tenth of a percent */
25 __u32 tq; /* Time quanta (TQ) in nanoseconds */
26 __u32 prop_seg; /* Propagation segment in TQs */
27 __u32 phase_seg1; /* Phase buffer segment 1 in TQs */
28 __u32 phase_seg2; /* Phase buffer segment 2 in TQs */
29 __u32 sjw; /* Synchronisation jump width in TQs */
30 __u32 brp; /* Bit-rate prescaler */
34 * CAN harware-dependent bit-timing constant
36 * Used for calculating and checking bit-timing parameters
38 struct can_bittiming_const {
39 char name[16]; /* Name of the CAN controller hardware */
40 __u32 tseg1_min; /* Time segement 1 = prop_seg + phase_seg1 */
41 __u32 tseg1_max;
42 __u32 tseg2_min; /* Time segement 2 = phase_seg2 */
43 __u32 tseg2_max;
44 __u32 sjw_max; /* Synchronisation jump width */
45 __u32 brp_min; /* Bit-rate prescaler */
46 __u32 brp_max;
47 __u32 brp_inc;
51 * CAN clock parameters
53 struct can_clock {
54 __u32 freq; /* CAN system clock frequency in Hz */
58 * CAN operational and error states
60 enum can_state {
61 CAN_STATE_ERROR_ACTIVE = 0, /* RX/TX error count < 96 */
62 CAN_STATE_ERROR_WARNING, /* RX/TX error count < 128 */
63 CAN_STATE_ERROR_PASSIVE, /* RX/TX error count < 256 */
64 CAN_STATE_BUS_OFF, /* RX/TX error count >= 256 */
65 CAN_STATE_STOPPED, /* Device is stopped */
66 CAN_STATE_SLEEPING, /* Device is sleeping */
67 CAN_STATE_MAX
71 * CAN bus error counters
73 struct can_berr_counter {
74 __u16 txerr;
75 __u16 rxerr;
79 * CAN controller mode
81 struct can_ctrlmode {
82 __u32 mask;
83 __u32 flags;
86 #define CAN_CTRLMODE_LOOPBACK 0x01 /* Loopback mode */
87 #define CAN_CTRLMODE_LISTENONLY 0x02 /* Listen-only mode */
88 #define CAN_CTRLMODE_3_SAMPLES 0x04 /* Triple sampling mode */
89 #define CAN_CTRLMODE_ONE_SHOT 0x08 /* One-Shot mode */
90 #define CAN_CTRLMODE_BERR_REPORTING 0x10 /* Bus-error reporting */
93 * CAN device statistics
95 struct can_device_stats {
96 __u32 bus_error; /* Bus errors */
97 __u32 error_warning; /* Changes to error warning state */
98 __u32 error_passive; /* Changes to error passive state */
99 __u32 bus_off; /* Changes to bus off state */
100 __u32 arbitration_lost; /* Arbitration lost errors */
101 __u32 restarts; /* CAN controller re-starts */
105 * CAN netlink interface
107 enum {
108 IFLA_CAN_UNSPEC,
109 IFLA_CAN_BITTIMING,
110 IFLA_CAN_BITTIMING_CONST,
111 IFLA_CAN_CLOCK,
112 IFLA_CAN_STATE,
113 IFLA_CAN_CTRLMODE,
114 IFLA_CAN_RESTART_MS,
115 IFLA_CAN_RESTART,
116 IFLA_CAN_BERR_COUNTER,
117 __IFLA_CAN_MAX
120 #define IFLA_CAN_MAX (__IFLA_CAN_MAX - 1)
122 #endif /* CAN_NETLINK_H */