2 /* Linux driver for Disk-On-Chip devices */
3 /* Probe routines common to all DoC devices */
4 /* (C) 1999 Machine Vision Holdings, Inc. */
5 /* (C) 1999-2003 David Woodhouse <dwmw2@infradead.org> */
9 In order to ensure that the BIOS checksum is correct at boot time, and
10 hence that the onboard BIOS extension gets executed, the DiskOnChip
11 goes into reset mode when it is read sequentially: all registers
12 return 0xff until the chip is woken up again by writing to the
15 Unfortunately, this means that the probe for the DiskOnChip is unsafe,
16 because one of the first things it does is write to where it thinks
17 the DOCControl register should be - which may well be shared memory
18 for another device. I've had machines which lock up when this is
19 attempted. Hence the possibility to do a passive probe, which will fail
20 to detect a chip in reset mode, but is at least guaranteed not to lock
23 If you have this problem, uncomment the following line:
24 #define DOC_PASSIVE_PROBE
29 Millennium driver has been merged into DOC2000 driver.
31 The old Millennium-only driver has been retained just in case there
32 are problems with the new code. If the combined driver doesn't work
33 for you, you can try the old one by undefining DOC_SINGLE_DRIVER
34 below and also enabling it in your configuration. If this fixes the
35 problems, please send a report to the MTD mailing list at
36 <linux-mtd@lists.infradead.org>.
38 #define DOC_SINGLE_DRIVER
40 #include <linux/kernel.h>
41 #include <linux/module.h>
42 #include <asm/errno.h>
44 #include <linux/delay.h>
45 #include <linux/slab.h>
46 #include <linux/init.h>
47 #include <linux/types.h>
49 #include <linux/mtd/mtd.h>
50 #include <linux/mtd/nand.h>
51 #include <linux/mtd/doc2000.h>
54 static unsigned long doc_config_location
= CONFIG_MTD_DOCPROBE_ADDRESS
;
55 module_param(doc_config_location
, ulong
, 0);
56 MODULE_PARM_DESC(doc_config_location
, "Physical memory address at which to probe for DiskOnChip");
58 static unsigned long __initdata doc_locations
[] = {
59 #if defined (__alpha__) || defined(__i386__) || defined(__x86_64__)
60 #ifdef CONFIG_MTD_DOCPROBE_HIGH
61 0xfffc8000, 0xfffca000, 0xfffcc000, 0xfffce000,
62 0xfffd0000, 0xfffd2000, 0xfffd4000, 0xfffd6000,
63 0xfffd8000, 0xfffda000, 0xfffdc000, 0xfffde000,
64 0xfffe0000, 0xfffe2000, 0xfffe4000, 0xfffe6000,
65 0xfffe8000, 0xfffea000, 0xfffec000, 0xfffee000,
66 #else /* CONFIG_MTD_DOCPROBE_HIGH */
67 0xc8000, 0xca000, 0xcc000, 0xce000,
68 0xd0000, 0xd2000, 0xd4000, 0xd6000,
69 0xd8000, 0xda000, 0xdc000, 0xde000,
70 0xe0000, 0xe2000, 0xe4000, 0xe6000,
71 0xe8000, 0xea000, 0xec000, 0xee000,
72 #endif /* CONFIG_MTD_DOCPROBE_HIGH */
74 #warning Unknown architecture for DiskOnChip. No default probe locations defined
78 /* doccheck: Probe a given memory window to see if there's a DiskOnChip present */
80 static inline int __init
doccheck(void __iomem
*potential
, unsigned long physadr
)
82 void __iomem
*window
=potential
;
83 unsigned char tmp
, tmpb
, tmpc
, ChipID
;
84 #ifndef DOC_PASSIVE_PROBE
88 /* Routine copied from the Linux DOC driver */
90 #ifdef CONFIG_MTD_DOCPROBE_55AA
91 /* Check for 0x55 0xAA signature at beginning of window,
92 this is no longer true once we remove the IPL (for Millennium */
93 if (ReadDOC(window
, Sig1
) != 0x55 || ReadDOC(window
, Sig2
) != 0xaa)
95 #endif /* CONFIG_MTD_DOCPROBE_55AA */
97 #ifndef DOC_PASSIVE_PROBE
98 /* It's not possible to cleanly detect the DiskOnChip - the
99 * bootup procedure will put the device into reset mode, and
100 * it's not possible to talk to it without actually writing
101 * to the DOCControl register. So we store the current contents
102 * of the DOCControl register's location, in case we later decide
103 * that it's not a DiskOnChip, and want to put it back how we
106 tmp2
= ReadDOC(window
, DOCControl
);
108 /* Reset the DiskOnChip ASIC */
109 WriteDOC(DOC_MODE_CLR_ERR
| DOC_MODE_MDWREN
| DOC_MODE_RESET
,
111 WriteDOC(DOC_MODE_CLR_ERR
| DOC_MODE_MDWREN
| DOC_MODE_RESET
,
114 /* Enable the DiskOnChip ASIC */
115 WriteDOC(DOC_MODE_CLR_ERR
| DOC_MODE_MDWREN
| DOC_MODE_NORMAL
,
117 WriteDOC(DOC_MODE_CLR_ERR
| DOC_MODE_MDWREN
| DOC_MODE_NORMAL
,
119 #endif /* !DOC_PASSIVE_PROBE */
121 /* We need to read the ChipID register four times. For some
122 newer DiskOnChip 2000 units, the first three reads will
123 return the DiskOnChip Millennium ident. Don't ask. */
124 ChipID
= ReadDOC(window
, ChipID
);
127 case DOC_ChipID_Doc2k
:
128 /* Check the TOGGLE bit in the ECC register */
129 tmp
= ReadDOC(window
, 2k_ECCStatus
) & DOC_TOGGLE_BIT
;
130 tmpb
= ReadDOC(window
, 2k_ECCStatus
) & DOC_TOGGLE_BIT
;
131 tmpc
= ReadDOC(window
, 2k_ECCStatus
) & DOC_TOGGLE_BIT
;
132 if (tmp
!= tmpb
&& tmp
== tmpc
)
136 case DOC_ChipID_DocMil
:
137 /* Check for the new 2000 with Millennium ASIC */
138 ReadDOC(window
, ChipID
);
139 ReadDOC(window
, ChipID
);
140 if (ReadDOC(window
, ChipID
) != DOC_ChipID_DocMil
)
141 ChipID
= DOC_ChipID_Doc2kTSOP
;
143 /* Check the TOGGLE bit in the ECC register */
144 tmp
= ReadDOC(window
, ECCConf
) & DOC_TOGGLE_BIT
;
145 tmpb
= ReadDOC(window
, ECCConf
) & DOC_TOGGLE_BIT
;
146 tmpc
= ReadDOC(window
, ECCConf
) & DOC_TOGGLE_BIT
;
147 if (tmp
!= tmpb
&& tmp
== tmpc
)
151 case DOC_ChipID_DocMilPlus16
:
152 case DOC_ChipID_DocMilPlus32
:
154 /* Possible Millennium+, need to do more checks */
155 #ifndef DOC_PASSIVE_PROBE
156 /* Possibly release from power down mode */
157 for (tmp
= 0; (tmp
< 4); tmp
++)
158 ReadDOC(window
, Mplus_Power
);
160 /* Reset the DiskOnChip ASIC */
161 tmp
= DOC_MODE_RESET
| DOC_MODE_MDWREN
| DOC_MODE_RST_LAT
|
163 WriteDOC(tmp
, window
, Mplus_DOCControl
);
164 WriteDOC(~tmp
, window
, Mplus_CtrlConfirm
);
167 /* Enable the DiskOnChip ASIC */
168 tmp
= DOC_MODE_NORMAL
| DOC_MODE_MDWREN
| DOC_MODE_RST_LAT
|
170 WriteDOC(tmp
, window
, Mplus_DOCControl
);
171 WriteDOC(~tmp
, window
, Mplus_CtrlConfirm
);
173 #endif /* !DOC_PASSIVE_PROBE */
175 ChipID
= ReadDOC(window
, ChipID
);
178 case DOC_ChipID_DocMilPlus16
:
179 case DOC_ChipID_DocMilPlus32
:
180 /* Check the TOGGLE bit in the toggle register */
181 tmp
= ReadDOC(window
, Mplus_Toggle
) & DOC_TOGGLE_BIT
;
182 tmpb
= ReadDOC(window
, Mplus_Toggle
) & DOC_TOGGLE_BIT
;
183 tmpc
= ReadDOC(window
, Mplus_Toggle
) & DOC_TOGGLE_BIT
;
184 if (tmp
!= tmpb
&& tmp
== tmpc
)
193 #ifdef CONFIG_MTD_DOCPROBE_55AA
194 printk(KERN_DEBUG
"Possible DiskOnChip with unknown ChipID %2.2X found at 0x%lx\n",
197 #ifndef DOC_PASSIVE_PROBE
198 /* Put back the contents of the DOCControl register, in case it's not
199 * actually a DiskOnChip.
201 WriteDOC(tmp2
, window
, DOCControl
);
206 printk(KERN_WARNING
"DiskOnChip failed TOGGLE test, dropping.\n");
208 #ifndef DOC_PASSIVE_PROBE
209 /* Put back the contents of the DOCControl register: it's not a DiskOnChip */
210 WriteDOC(tmp2
, window
, DOCControl
);
217 extern void DoC2k_init(struct mtd_info
*);
218 extern void DoCMil_init(struct mtd_info
*);
219 extern void DoCMilPlus_init(struct mtd_info
*);
221 static void __init
DoC_Probe(unsigned long physadr
)
223 void __iomem
*docptr
;
224 struct DiskOnChip
*this;
225 struct mtd_info
*mtd
;
228 char *name
= namebuf
;
229 void (*initroutine
)(struct mtd_info
*) = NULL
;
231 docptr
= ioremap(physadr
, DOC_IOREMAP_LEN
);
236 if ((ChipID
= doccheck(docptr
, physadr
))) {
237 if (ChipID
== DOC_ChipID_Doc2kTSOP
) {
238 /* Remove this at your own peril. The hardware driver works but nothing prevents you from erasing bad blocks */
239 printk(KERN_NOTICE
"Refusing to drive DiskOnChip 2000 TSOP until Bad Block Table is correctly supported by INFTL\n");
244 mtd
= kzalloc(sizeof(struct DiskOnChip
) + sizeof(struct mtd_info
), GFP_KERNEL
);
246 printk(KERN_WARNING
"Cannot allocate memory for data structures. Dropping.\n");
251 this = (struct DiskOnChip
*)(&mtd
[1]);
253 this->virtadr
= docptr
;
254 this->physadr
= physadr
;
255 this->ChipID
= ChipID
;
256 sprintf(namebuf
, "with ChipID %2.2X", ChipID
);
259 case DOC_ChipID_Doc2kTSOP
:
261 initroutine
= symbol_request(DoC2k_init
);
264 case DOC_ChipID_Doc2k
:
266 initroutine
= symbol_request(DoC2k_init
);
269 case DOC_ChipID_DocMil
:
271 #ifdef DOC_SINGLE_DRIVER
272 initroutine
= symbol_request(DoC2k_init
);
274 initroutine
= symbol_request(DoCMil_init
);
275 #endif /* DOC_SINGLE_DRIVER */
278 case DOC_ChipID_DocMilPlus16
:
279 case DOC_ChipID_DocMilPlus32
:
280 name
="MillenniumPlus";
281 initroutine
= symbol_request(DoCMilPlus_init
);
287 symbol_put_addr(initroutine
);
290 printk(KERN_NOTICE
"Cannot find driver for DiskOnChip %s at 0x%lX\n", name
, physadr
);
297 /****************************************************************************
301 ****************************************************************************/
303 static int __init
init_doc(void)
307 if (doc_config_location
) {
308 printk(KERN_INFO
"Using configured DiskOnChip probe address 0x%lx\n", doc_config_location
);
309 DoC_Probe(doc_config_location
);
311 for (i
=0; (doc_locations
[i
] != 0xffffffff); i
++) {
312 DoC_Probe(doc_locations
[i
]);
315 /* No banner message any more. Print a message if no DiskOnChip
316 found, so the user knows we at least tried. */
318 printk(KERN_INFO
"No recognised DiskOnChip devices found\n");
322 module_init(init_doc
);
324 MODULE_LICENSE("GPL");
325 MODULE_AUTHOR("David Woodhouse <dwmw2@infradead.org>");
326 MODULE_DESCRIPTION("Probe code for DiskOnChip 2000 and Millennium devices");