include/linux/regulator/consumer.h

   1 /*
   2  * consumer.h -- SoC Regulator consumer support.
   3  *
   4  * Copyright (C) 2007, 2008 Wolfson Microelectronics PLC.
   5  *
   6  * Author: Liam Girdwood <lrg@slimlogic.co.uk>
   7  *
   8  * This program is free software; you can redistribute it and/or modify
   9  * it under the terms of the GNU General Public License version 2 as
  10  * published by the Free Software Foundation.
  11  *
  12  * Regulator Consumer Interface.
  13  *
  14  * A Power Management Regulator framework for SoC based devices.
  15  * Features:-
  16  *   o Voltage and current level control.
  17  *   o Operating mode control.
  18  *   o Regulator status.
  19  *   o sysfs entries for showing client devices and status
  20  *
  21  * EXPERIMENTAL FEATURES:
  22  *   Dynamic Regulator operating Mode Switching (DRMS) - allows regulators
  23  *   to use most efficient operating mode depending upon voltage and load and
  24  *   is transparent to client drivers.
  25  *
  26  *   e.g. Devices x,y,z share regulator r. Device x and y draw 20mA each during
  27  *   IO and 1mA at idle. Device z draws 100mA when under load and 5mA when
  28  *   idling. Regulator r has > 90% efficiency in NORMAL mode at loads > 100mA
  29  *   but this drops rapidly to 60% when below 100mA. Regulator r has > 90%
  30  *   efficiency in IDLE mode at loads < 10mA. Thus regulator r will operate
  31  *   in normal mode for loads > 10mA and in IDLE mode for load <= 10mA.
  32  *
  33  */
  34
  35 #ifndef __LINUX_REGULATOR_CONSUMER_H_
  36 #define __LINUX_REGULATOR_CONSUMER_H_
  37
  38 #include <linux/device.h>
  39
  40 /*
  41  * Regulator operating modes.
  42  *
  43  * Regulators can run in a variety of different operating modes depending on
  44  * output load. This allows further system power savings by selecting the
  45  * best (and most efficient) regulator mode for a desired load.
  46  *
  47  * Most drivers will only care about NORMAL. The modes below are generic and
  48  * will probably not match the naming convention of your regulator data sheet
  49  * but should match the use cases in the datasheet.
  50  *
  51  * In order of power efficiency (least efficient at top).
  52  *
  53  *  Mode       Description
  54  *  FAST       Regulator can handle fast changes in it's load.
  55  *             e.g. useful in CPU voltage & frequency scaling where
  56  *             load can quickly increase with CPU frequency increases.
  57  *
  58  *  NORMAL     Normal regulator power supply mode. Most drivers will
  59  *             use this mode.
  60  *
  61  *  IDLE       Regulator runs in a more efficient mode for light
  62  *             loads. Can be used for devices that have a low power
  63  *             requirement during periods of inactivity. This mode
  64  *             may be more noisy than NORMAL and may not be able
  65  *             to handle fast load switching.
  66  *
  67  *  STANDBY    Regulator runs in the most efficient mode for very
  68  *             light loads. Can be used by devices when they are
  69  *             in a sleep/standby state. This mode is likely to be
  70  *             the most noisy and may not be able to handle fast load
  71  *             switching.
  72  *
  73  * NOTE: Most regulators will only support a subset of these modes. Some
  74  * will only just support NORMAL.
  75  *
  76  * These modes can be OR'ed together to make up a mask of valid register modes.
  77  */
  78
  79 #define REGULATOR_MODE_FAST                     0x1
  80 #define REGULATOR_MODE_NORMAL                   0x2
  81 #define REGULATOR_MODE_IDLE                     0x4
  82 #define REGULATOR_MODE_STANDBY                  0x8
  83
  84 /*
  85  * Regulator notifier events.
  86  *
  87  * UNDER_VOLTAGE  Regulator output is under voltage.
  88  * OVER_CURRENT   Regulator output current is too high.
  89  * REGULATION_OUT Regulator output is out of regulation.
  90  * FAIL           Regulator output has failed.
  91  * OVER_TEMP      Regulator over temp.
  92  * FORCE_DISABLE  Regulator forcibly shut down by software.
  93  * VOLTAGE_CHANGE Regulator voltage changed.
  94  * DISABLE        Regulator was disabled.
  95  *
  96  * NOTE: These events can be OR'ed together when passed into handler.
  97  */
  98
  99 #define REGULATOR_EVENT_UNDER_VOLTAGE           0x01
 100 #define REGULATOR_EVENT_OVER_CURRENT            0x02
 101 #define REGULATOR_EVENT_REGULATION_OUT          0x04
 102 #define REGULATOR_EVENT_FAIL                    0x08
 103 #define REGULATOR_EVENT_OVER_TEMP               0x10
 104 #define REGULATOR_EVENT_FORCE_DISABLE           0x20
 105 #define REGULATOR_EVENT_VOLTAGE_CHANGE          0x40
 106 #define REGULATOR_EVENT_DISABLE                 0x80
 107
 108 struct regulator;
 109
 110 /**
 111  * struct regulator_bulk_data - Data used for bulk regulator operations.
 112  *
 113  * @supply:   The name of the supply.  Initialised by the user before
 114  *            using the bulk regulator APIs.
 115  * @consumer: The regulator consumer for the supply.  This will be managed
 116  *            by the bulk API.
 117  *
 118  * The regulator APIs provide a series of regulator_bulk_() API calls as
 119  * a convenience to consumers which require multiple supplies.  This
 120  * structure is used to manage data for these calls.
 121  */
 122 struct regulator_bulk_data {
 123         const char *supply;
 124         struct regulator *consumer;
 125
 126         /* private: Internal use */
 127         int ret;
 128 };
 129
 130 #if defined(CONFIG_REGULATOR)
 131
 132 /* regulator get and put */
 133 struct regulator *__must_check regulator_get(struct device *dev,
 134                                              const char *id);
 135 struct regulator *__must_check regulator_get_exclusive(struct device *dev,
 136                                                        const char *id);
 137 void regulator_put(struct regulator *regulator);
 138
 139 /* regulator output control and status */
 140 int regulator_enable(struct regulator *regulator);
 141 int regulator_disable(struct regulator *regulator);
 142 int regulator_force_disable(struct regulator *regulator);
 143 int regulator_is_enabled(struct regulator *regulator);
 144 int regulator_disable_deferred(struct regulator *regulator, int ms);
 145
 146 int regulator_bulk_get(struct device *dev, int num_consumers,
 147                        struct regulator_bulk_data *consumers);
 148 int regulator_bulk_enable(int num_consumers,
 149                           struct regulator_bulk_data *consumers);
 150 int regulator_bulk_disable(int num_consumers,
 151                            struct regulator_bulk_data *consumers);
 152 int regulator_bulk_force_disable(int num_consumers,
 153                            struct regulator_bulk_data *consumers);
 154 void regulator_bulk_free(int num_consumers,
 155                          struct regulator_bulk_data *consumers);
 156
 157 int regulator_count_voltages(struct regulator *regulator);
 158 int regulator_list_voltage(struct regulator *regulator, unsigned selector);
 159 int regulator_is_supported_voltage(struct regulator *regulator,
 160                                    int min_uV, int max_uV);
 161 int regulator_set_voltage(struct regulator *regulator, int min_uV, int max_uV);
 162 int regulator_set_voltage_time(struct regulator *regulator,
 163                                int old_uV, int new_uV);
 164 int regulator_get_voltage(struct regulator *regulator);
 165 int regulator_sync_voltage(struct regulator *regulator);
 166 int regulator_set_current_limit(struct regulator *regulator,
 167                                int min_uA, int max_uA);
 168 int regulator_get_current_limit(struct regulator *regulator);
 169
 170 int regulator_set_mode(struct regulator *regulator, unsigned int mode);
 171 unsigned int regulator_get_mode(struct regulator *regulator);
 172 int regulator_set_optimum_mode(struct regulator *regulator, int load_uA);
 173
 174 /* regulator notifier block */
 175 int regulator_register_notifier(struct regulator *regulator,
 176                               struct notifier_block *nb);
 177 int regulator_unregister_notifier(struct regulator *regulator,
 178                                 struct notifier_block *nb);
 179
 180 /* driver data - core doesn't touch */
 181 void *regulator_get_drvdata(struct regulator *regulator);
 182 void regulator_set_drvdata(struct regulator *regulator, void *data);
 183
 184 #else
 185
 186 /*
 187  * Make sure client drivers will still build on systems with no software
 188  * controllable voltage or current regulators.
 189  */
 190 static inline struct regulator *__must_check regulator_get(struct device *dev,
 191         const char *id)
 192 {
 193         /* Nothing except the stubbed out regulator API should be
 194          * looking at the value except to check if it is an error
 195          * value. Drivers are free to handle NULL specifically by
 196          * skipping all regulator API calls, but they don't have to.
 197          * Drivers which don't, should make sure they properly handle
 198          * corner cases of the API, such as regulator_get_voltage()
 199          * returning 0.
 200          */
 201         return NULL;
 202 }
 203 static inline void regulator_put(struct regulator *regulator)
 204 {
 205 }
 206
 207 static inline int regulator_enable(struct regulator *regulator)
 208 {
 209         return 0;
 210 }
 211
 212 static inline int regulator_disable(struct regulator *regulator)
 213 {
 214         return 0;
 215 }
 216
 217 static inline int regulator_force_disable(struct regulator *regulator)
 218 {
 219         return 0;
 220 }
 221
 222 static inline int regulator_disable_deferred(struct regulator *regulator,
 223                                              int ms)
 224 {
 225         return 0;
 226 }
 227
 228 static inline int regulator_is_enabled(struct regulator *regulator)
 229 {
 230         return 1;
 231 }
 232
 233 static inline int regulator_bulk_get(struct device *dev,
 234                                      int num_consumers,
 235                                      struct regulator_bulk_data *consumers)
 236 {
 237         return 0;
 238 }
 239
 240 static inline int regulator_bulk_enable(int num_consumers,
 241                                         struct regulator_bulk_data *consumers)
 242 {
 243         return 0;
 244 }
 245
 246 static inline int regulator_bulk_disable(int num_consumers,
 247                                          struct regulator_bulk_data *consumers)
 248 {
 249         return 0;
 250 }
 251
 252 static inline int regulator_bulk_force_disable(int num_consumers,
 253                                         struct regulator_bulk_data *consumers)
 254 {
 255         return 0;
 256 }
 257
 258 static inline void regulator_bulk_free(int num_consumers,
 259                                        struct regulator_bulk_data *consumers)
 260 {
 261 }
 262
 263 static inline int regulator_set_voltage(struct regulator *regulator,
 264                                         int min_uV, int max_uV)
 265 {
 266         return 0;
 267 }
 268
 269 static inline int regulator_get_voltage(struct regulator *regulator)
 270 {
 271         return 0;
 272 }
 273
 274 static inline int regulator_set_current_limit(struct regulator *regulator,
 275                                              int min_uA, int max_uA)
 276 {
 277         return 0;
 278 }
 279
 280 static inline int regulator_get_current_limit(struct regulator *regulator)
 281 {
 282         return 0;
 283 }
 284
 285 static inline int regulator_set_mode(struct regulator *regulator,
 286         unsigned int mode)
 287 {
 288         return 0;
 289 }
 290
 291 static inline unsigned int regulator_get_mode(struct regulator *regulator)
 292 {
 293         return REGULATOR_MODE_NORMAL;
 294 }
 295
 296 static inline int regulator_set_optimum_mode(struct regulator *regulator,
 297                                         int load_uA)
 298 {
 299         return REGULATOR_MODE_NORMAL;
 300 }
 301
 302 static inline int regulator_register_notifier(struct regulator *regulator,
 303                               struct notifier_block *nb)
 304 {
 305         return 0;
 306 }
 307
 308 static inline int regulator_unregister_notifier(struct regulator *regulator,
 309                                 struct notifier_block *nb)
 310 {
 311         return 0;
 312 }
 313
 314 static inline void *regulator_get_drvdata(struct regulator *regulator)
 315 {
 316         return NULL;
 317 }
 318
 319 static inline void regulator_set_drvdata(struct regulator *regulator,
 320         void *data)
 321 {
 322 }
 323
 324 #endif
 325
 326 #endif