mb/google/nissa/var/rull: add ssd timing and modify ssd GPIO pins of rtd3

[coreboot2.git] / src / mainboard / pcengines / apu2 / variants / apu5 / devicetree.cb

# SPDX-License-Identifier: GPL-2.0-only

chip northbridge/amd/pi/00730F01
        device domain 0 on
                subsystemid 0x1022 0x1410 inherit
                device ref iommu                on end
                device ref gpp_bridge_0         on end  # mPCIe slot 2 (on GFX lane)
                device ref gpp_bridge_1         on end  # LAN3
                device ref gpp_bridge_2         on end  # LAN2
                device ref gpp_bridge_3         on end  # LAN1
                device ref gpp_bridge_4         on end  # mPCIe slot 1

                chip southbridge/amd/pi/hudson          # it is under NB/SB Link, but on the same pci bus
                        device ref xhci         on end  # XHCI HC0 muxed with EHCI 2
                        device ref sata         on end
                        device ref ehci_0       on end  # USB EHCI0 usb[0:3] is connected
                        device ref ehci_1       on end  # USB EHCI1 usb[4:7]
                        device ref lpc_bridge   on
                                chip superio/nuvoton/nct5104d # SIO NCT5104D
                                        register "irq_trigger_type" = "0"
                                        device pnp 2e.0 off end
                                        device pnp 2e.2 on
                                                io 0x60 = 0x3f8
                                                irq 0x70 = 4
                                        end
                                        device pnp 2e.3 on
                                                io 0x60 = 0x2f8
                                                irq 0x70 = 3
                                        end
                                        device pnp 2e.10 on
                                                # UART C is conditionally turned on
                                                io 0x60 = 0x3e8
                                                irq 0x70 = 4
                                        end
                                        device pnp 2e.11 on
                                                # UART D is conditionally turned on
                                                io 0x60 = 0x2e8
                                                irq 0x70 = 3
                                        end
                                        device pnp 2e.008 off end
                                        device pnp 2e.108 off end
                                        device pnp 2e.f off end
                                        device pnp 2e.007 off end
                                        device pnp 2e.107 off end
                                        device pnp 2e.607 off end
                                end # SIO NCT5104D
                                chip drivers/pc80/tpm
                                        device pnp 0c31.0 on end
                                end # LPC TPM
                        end
                        device ref ehci_2       on end  # USB EHCI2 usb[8:7] - muxed with XHCI
                end
        end
end